HYBRID MODELING AND ANALYSIS OF STRUCTURAL DYNAMIC OF A BALL SCREW FEED DRIVE SYSTEM

In order to get the complete structural dynamic of the ball screw drive this paper proposes a hybrid modeling method. The dynamic characteristic of a ball screw is analyzed by a continuous beam approach having axial, torsional and flexural dynamics. The dynamic equation of a rotating screw subjected to the axially moving load with general boundary conditions are obtained through Lagrangian approach. Compared with the experimental results, the model can accurately capture the structural dynamics of the ball screw drive. Influences of parameters, such as table mass, screw pitch, table position and preload on the structural dynamic of the ball screw drive are discussed. Finally, the hybrid model is integrated into a servo control system, which makes an integrated design of the servomechanisms possible. DOI: http://dx.doi.org/10.5755/j01.mech.19.3.4662

[1]  Ryozo Nagamune,et al.  Tracking Control of Flexible Ball Screw Drives With Runout Effect and Mass Variation , 2012, IEEE Transactions on Industrial Electronics.

[2]  Guo-Hua Feng,et al.  Investigation of ball screw preload variation based on dynamic modeling of a preload adjustable feed-drive system and spectrum analysis of ball-nuts sensed vibration signals , 2012 .

[3]  Chinedum E. Okwudire,et al.  Minimum Tracking Error Control of Flexible Ball Screw Drives Using a Discrete-Time Sliding Mode Controller , 2009 .

[4]  Christian Brecher,et al.  Machine tool feed drives , 2011 .

[5]  Chinedum E. Okwudire,et al.  Hybrid Modeling of Ball Screw Drives With Coupled Axial, Torsional, and Lateral Dynamics , 2009 .

[6]  Kripa K. Varanasi,et al.  The Dynamics of Lead-Screw Drives: Low-Order Modeling and , 2004 .

[7]  C. C. Cheng,et al.  Vibration analysis of a high-speed spindle under the action of a moving mass , 2004 .

[8]  Rogelio L. Hecker,et al.  Modeling and vibration mode analysis of a ball screw drive , 2012 .

[9]  X. H. Cao,et al.  PARAMETER SENSITIVITY ANALYSIS OF AXIAL VIBRATION FOR LEAD-SCREW FEED DRIVES WITH TIME-VARYING FRAMEWORK , 2011 .

[10]  R. Whalley,et al.  Hybrid modelling of machine tool axis drives , 2005 .

[11]  Alexander Verl,et al.  Expedient modeling of ball screw feed drives , 2012, Prod. Eng..

[12]  Sung-Chong Chung,et al.  A systematic approach to design high-performance feed drive systems , 2005 .

[13]  Jenq-Shyong Chen,et al.  Mechanical model and contouring analysis of high-speed ball-screw drive systems with compliance effect , 2004 .