Photophysics and Photocurrent Generation in Polythiophene/Polyfluorene Copolymer Blends

Here, studies on the evolution of photophysics and device performance with annealing of blends of poly(3‐hexylthiophene) with the two polyfluorene copolymers poly((9,9‐dioctylfluorene)‐2,7‐diyl‐alt‐[4,7‐bis(3‐hexylthien‐5‐yl)‐2,1,3‐benzothiadiazole]‐2′,2′′‐diyl) (F8TBT) and poly(9,9‐dioctylfluorene‐co‐benzothiadiazole) (F8BT) are reported. In blends with F8TBT, P3HT is found to reorganize at low annealing temperatures (100 °C or below), evidenced by a redshift of both absorption and photoluminescence (PL), and by a decrease in PL lifetime. Annealing to 140 °C, however, is found to optimize device performance, accompanied by an increase in PL efficiency and lifetime. Grazing‐incidence small‐angle X‐ray scattering is also performed to study the evolution in film nanomorphology with annealing, with the 140 °C‐annealed film showing enhanced phase separation. It is concluded that reorganization of P3HT alone is not sufficient to optimize device performance but must also be accompanied by a coarsening of the morphology to promote charge separation. The shape of the photocurrent action spectra of P3HT:F8TBT devices is also studied, aided by optical modeling of the absorption spectrum of the blend in a device structure. Changes in the shape of the photocurrent action spectra with annealing are observed, and these are attributed to changes in the relative contribution of each polymer to photocurrent as morphology and polymer conformation evolve. In particular, in as‐spun films from xylene, photocurrent is preferentially generated from ordered P3HT segments attributed to the increased charge separation efficiency in ordered P3HT compared to disordered P3HT. For optimized devices, photocurrent is efficiently generated from both P3HT and F8TBT. In contrast to blends with F8TBT, P3HT is only found to reorganize in blends with F8BT at annealing temperatures of over 200 °C. The low efficiency of the P3HT:F8BT system can then be attributed to poor charge generation and separation efficiencies that result from the failure of P3HT to reorganize.

[1]  C. McNeill,et al.  Efficient Polythiophene/Polyfluorene Copolymer Bulk Heterojunction Photovoltaic Devices: Device Physics and Annealing Effects , 2008 .

[2]  C. McNeill,et al.  Evolution of the nanomorphology of photovoltaic polyfluorene blends: sub-100 nm resolution with x-ray spectromicroscopy , 2008, Nanotechnology.

[3]  Keng S. Liang,et al.  Simultaneous Use of Small‐ and Wide‐Angle X‐ray Techniques to Analyze Nanometerscale Phase Separation in Polymer Heterojunction Solar Cells , 2008 .

[4]  D. Bradley,et al.  Bright red emission from single layer polymer light-emitting devices based on blends of regioregular P3HT and F8BT☆ , 2005 .

[5]  Michael D. McGehee,et al.  Polymer-based solar cells , 2007 .

[6]  Richard H. Friend,et al.  Dual electron donor/electron acceptor character of a conjugated polymer in efficient photovoltaic diodes , 2007 .

[7]  H. Sirringhaus,et al.  Quantum efficiency of ambipolar light-emitting polymer field-effect transistors , 2008 .

[8]  Jenny Clark,et al.  Molecular-weight dependence of interchain polaron delocalization and exciton bandwidth in high-mobility conjugated polymers , 2006 .

[9]  H. Sirringhaus,et al.  Effects of packing structure on the optoelectronic and charge transport properties in poly(9,9-di-n-octylfluorene-alt-benzothiadiazole). , 2005, Journal of the American Chemical Society.

[10]  Neil C. Greenham,et al.  A microscopic model for the behavior of nanostructured organic photovoltaic devices , 2007 .

[11]  P. Müller‐Buschbaum.  Grazing incidence small-angle X-ray scattering: an advanced scattering technique for the investigation of nanostructured polymer films , 2003, Analytical and bioanalytical chemistry.

[12]  Xiong Gong,et al.  Thermally Stable, Efficient Polymer Solar Cells with Nanoscale Control of the Interpenetrating Network Morphology , 2005 .

[13]  J. Jaczewska,et al.  Swelling of poly(3-alkylthiophene) films exposed to solvent vapors and humidity: Evaluation of solubility parameters , 2007 .

[14]  Valentin D. Mihailetchi,et al.  Charge Transport and Photocurrent Generation in Poly(3‐hexylthiophene): Methanofullerene Bulk‐Heterojunction Solar Cells , 2006 .

[15]  C. McNeill,et al.  Charge transport dynamics of polymer solar cells under operating conditions: Influence of trap filling , 2008 .

[16]  A J Heeger,et al.  Efficiency enhancement in low-bandgap polymer solar cells by processing with alkane dithiols. , 2007, Nature materials.

[17]  Jenny Clark,et al.  Role of intermolecular coupling in the photophysics of disordered organic semiconductors: aggregate emission in regioregular polythiophene. , 2007, Physical review letters.

[18]  D. Bradley,et al.  Organic Photovoltaic Devices Based on Blends of Regioregular Poly(3-hexylthiophene) and Poly(9,9-dioctylfluorene-co-benzothiadiazole) , 2004 .

[19]  P. Müller‐Buschbaum.  A Basic Introduction to Grazing Incidence Small-Angle X-Ray Scattering , 2009 .

[20]  R. Friend,et al.  Influence of Nanoscale Phase Separation on the Charge Generation Dynamics and Photovoltaic Performance of Conjugated Polymer Blends: Balancing Charge Generation and Separation , 2007 .

[21]  Stephen R. Forrest,et al.  Separation of geminate charge-pairs at donor–acceptor interfaces in disordered solids , 2004 .

[22]  N. E. Coates,et al.  Efficient Tandem Polymer Solar Cells Fabricated by All-Solution Processing , 2007, Science.

[23]  H. Sirringhaus,et al.  Effect of interchain interactions on the absorption and emission of poly(3-hexylthiophene) , 2003 .

[24]  E. Moons,et al.  Morphology and Phase Segregation of Spin-Casted Films of Polyfluorene/PCBM Blends , 2007 .

[25]  J. Kroon,et al.  Nanoscale structure of solar cells based on pure conjugated polymer blends , 2007 .

[26]  Fred Wudl,et al.  Light‐Emitting Polythiophenes , 2005 .

[27]  Akihiro Furube,et al.  Analysis of the excited states of regioregular polythiophene P3HT , 2008 .

[28]  D. Neher,et al.  Efficient Polymer Solar Cells Based on M3EH−PPV , 2005 .

[29]  Richard H. Friend,et al.  An improved experimental determination of external photoluminescence quantum efficiency , 1997 .