Application of Teaching: Learning Based optimization to Surface Integrity Parameters in Milling

No part of this journal may be reproduced or used in any form or by any means without written permission from the publisher, except for noncommercial, educational use including classroom teaching purposes. Product or company names used in this journal are for identification purposes only. Inclusion of the names of the products or companies does not indicate a claim of ownership by IGI Global of the trademark or registered trademark. The views expressed in this journal are those of the authors but not necessarily of IGI Global.

[1]  Du-Ming Tsai,et al.  A simulated annealing approach for optimization of multi-pass turning operations , 1996 .

[2]  M. A. Mannan,et al.  MACHINABILITY OF NICKEL-BASED HIGH TEMPERATURE ALLOYS , 2000 .

[3]  Konstantinos-Dionysios Bouzakis,et al.  Determination of the chip geometry, cutting force and roughness in free form surfaces finishing milling, with ball end tools , 2003 .

[4]  Dong Jianxin,et al.  The microstructural changes and their effect on CCGR after long time thermal exposure in DA718 and STD718 , 2003 .

[5]  M. Ali,et al.  Investigation of machining parameters for the multiple-response optimization of micro electrodischarge milling , 2009 .

[6]  Jose Mathew,et al.  Optimization of Material Removal Rate in Micro-EDM Using Artificial Neural Network and Genetic Algorithms , 2010 .

[7]  R V Rao,et al.  Parameters optimization of advanced machining processes using TLBO algorithm , 2011 .

[8]  R. Venkata Rao,et al.  Teaching-learning-based optimization: A novel method for constrained mechanical design optimization problems , 2011, Comput. Aided Des..

[9]  Nandkumar N. Bhopale,et al.  Investigation of surface integrity in high-speed ball end milling of cantilever shaped thin plate of Inconel 718 , 2012 .

[10]  Ali R. Yildiz,et al.  A comparative study of population-based optimization algorithms for turning operations , 2012, Inf. Sci..

[11]  R. Venkata Rao,et al.  Parameter optimization of modern machining processes using teaching-learning-based optimization algorithm , 2013, Eng. Appl. Artif. Intell..

[12]  Suhas S. Joshi,et al.  Experimental Investigation into the Effect of Ball End Milling Parameters on Surface Integrity of Inconel 718 , 2015, Journal of Materials Engineering and Performance.

[13]  K. Satheesh Kumar,et al.  Teaching Learning based Optimization , 2015 .

[14]  International Journal of Materials Forming and Machining Processes , 2022 .