The key characteristics of a drying method for biomass are, firstly, its ability to control temperature, steam flow and pressure drop and, secondly, its ability to stabilise the material flows, particularly the outgoing moisture content. This paper presents the usefulness and significance of using energy and mass balances to improve the measurements and control systems of a drying system of industrial size in order to fulfil the moisture content requirements for biomass compression. In order to assess the reliability and accuracy of the measurements a series of tests at four different temperature and pressure levels were conducted. By verifying the plant's energy and mass balances the accuracy of the measurements could be determined and the control system was evaluated. The test results are used to determine the energy and mass balances. The control system yields good stability for the pressure drop, the temperature and the gas flow.
[1]
A. S. Jensen.
Pressurized steam drying of sludge, bark and wood chips : Process offers full energy recovery and avoids air pollution
,
1996
.
[2]
Henk C. van Deventer,et al.
DRYING WITH SUPERHEATED STEAM
,
2001
.
[3]
Jonas Berghel,et al.
Basic design criteria and corresponding results performance of a pilot-scale fluidized superheated atmospheric condition steam dryer
,
2002
.
[4]
Javier Bilbao,et al.
Pressure drop in conical spouted beds
,
1993
.
[5]
M. A. Malek,et al.
Pressure Drop and Spoutable Bed Height in Spouted Beds
,
1965
.
[6]
Rogelio Moreno,et al.
SAWDUST FLUID-BED DRYING WITH HEATING TUBES
,
1998
.