SIMPLIFIED APPROACHES FOR CONTROLLING DC-DC POWER CONVERTERS

This paper represents the design procedures of different compensation schemes for voltage mode controlled (VMC) dc–dc switching converters. Proportional integral derivative (PID) controllers, Fuzzy logic controllers (FLC), parallel combination of PID and FLC, and FLC tuned by PI controller have been investigated. MATLAB software is used to depict the buck converter performance with each compensator type when it is electrically simulated, and analytically modeled using its equivalent transfer function (TF). The comparative study Results emphasize that FLC tuned by PI controller is superior to the other control strategies because of fast transient response, minimum steady state error and good disturbance rejection under various variations of the operating conditions. Hence, it achieves the most tightly output voltage regulation.

[1]  J. Hung,et al.  Evaluation of DSP-Based PID and Fuzzy Controllers for DC–DC Converters , 2009, IEEE Transactions on Industrial Electronics.

[2]  Abd-Alhalim Yatim,et al.  Dynamic evolution control for synchronous buck DC-DC converter: Theory, model and simulation , 2010, Simul. Model. Pract. Theory.

[3]  Türkay Dereli,et al.  Industrial applications of type-2 fuzzy sets and systems: A concise review , 2011, Comput. Ind..

[4]  Dawei Gao,et al.  Energy management strategy based on fuzzy logic for a fuel cell hybrid bus , 2008 .

[5]  Juing-Huei Su,et al.  Learning feedback controller design of switching converters via MATLAB/SIMULINK , 2002, IEEE Trans. Educ..

[6]  Yih-Guang Leu,et al.  Mean-based fuzzy identifier and control of uncertain nonlinear systems , 2010, Fuzzy Sets Syst..

[7]  Chin-Hsing Cheng,et al.  Design of output filter for inverters using fuzzy logic , 2011, Expert Syst. Appl..

[8]  Kamel Guesmi,et al.  Systematic design approach of fuzzy PID stabilizer for DC–DC converters , 2008 .

[9]  Amir M. Rahimi.  Addressing negative impedance instability problem of constant power loads: Comprehensive view encompassing entire system from the load to the source , 2008 .

[10]  F. Bouchafaa,et al.  Fuzzy Logic Control for the tracking of maximum power point of a PV system , 2011 .

[11]  İlyas Eker,et al.  Fuzzy logic control to be conventional method , 2006 .

[12]  Kamel Guesmi,et al.  Shifting nonlinear phenomena in a DC-DC converter using a fuzzy logic controller , 2008, Mathematics and Computers in Simulation.

[13]  Omer Deperlioglu,et al.  Adaptive fuzzy logic controller for DC-DC converters , 2009, Expert Syst. Appl..

[14]  Robert W. Erickson,et al.  Fundamentals of Power Electronics , 2001 .

[15]  Xin Liu,et al.  Simple digital PWM and PSM controlled DC-DC boost converter for luminance-regulated WLED driver , 2009 .

[16]  Soteris A. Kalogirou,et al.  Maximum power point tracking using a GA optimized fuzzy logic controller and its FPGA implementation , 2011 .

[17]  Ali Emadi,et al.  Suitability of the pulse adjustment technique to control single DC/DC choppers feeding vehicular constant power loads in parallel with conventional loads , 2007 .

[18]  John Y. Hung,et al.  Comparative evaluation of sliding mode fuzzy controller and PID controller for a boost converter , 2011 .

[19]  Jenica Ileana Corcau,et al.  Fuzzy logic controller as a power system stabilizer , 2007 .