Anti-reflection (AR) coatings made by sol–gel processes: A review

Abstract Traditionally, various vacuum-based processes, depending on material systems and properties, and chemical etching process have been used for producing different types of anti-reflection (AR) coating on different substrate materials. In this paper, the development of sol–gel derived AR coating on different substrates for various applications in the past 40 years are reviewed. These coatings possess good uniformity in thickness and properties which have met requirements for various applications. The major approaches to fabricate AR coating and their characteristics have been discussed. This paper outlines the major solution coating processes and design principles of AR coatings. Major fabrication processes used in AR coating technologies have been compared. Different solution chemistries developed for producing different materials for AR coating preparation have been extensively reviewed. The optical performance of different types of sol–gel-derived AR coatings have been summarized and comparison to the commercial AR coating produced by traditional technologies have been discussed. The sol–gel AR coating has been shown to possess comparable or superior performance to those produced by vacuum-based processes.

[1]  C. Brinker.  Sol-gel science , 1990 .

[2]  Din-Guo Chen,et al.  Anti-reflection (AR) coating meter , 1999 .

[3]  D. Partlow,et al.  Formation of broad band antireflective coatings on fused silica for high power laser applications , 1985 .

[4]  Jerald A. Britten,et al.  A SIMPLE THEORY FOR THE ENTRAINED FILM THICKNESS DURING MENISCUS COATING , 1993 .

[5]  H. Dislich,et al.  Amorphous and crystalline dip coatings obtained from organometallic solutions: Procedures, chemical processes and products , 1981 .

[6]  D. Meyerhofer.  Characteristics of resist films produced by spinning , 1978 .

[7]  M. Kikuchi.  Antiphospholipid antibodies in patients with collagen diseases , 1992 .

[8]  R. B. Pettit,et al.  Use of sol-gel thin films in solar energy applications☆ , 1986 .

[9]  Clément Sanchez,et al.  Sol-gel chemistry of transition metal oxides , 1988 .

[10]  S. F. Monaco,et al.  Reflectance of an Inhomogeneous Thin Film , 1961 .

[11]  H. Schmidt,et al.  One step antiglare solgel coating for screens by solgel techniques , 1997 .

[12]  R. Pettit,et al.  Antireflection Pyrex Envelopes for Parabolic Solar Collectors , 1983 .

[13]  B. E. Yoldas.  Introduction and effect of structural variations in inorganic polymers and glass networks , 1982 .

[14]  E. K. Hussmann.  Sol-Gel Coatings on Large Glass Substrates for Multilayer Interference Systems , 1998 .

[15]  P. Belleville,et al.  A scratch-resistant single-layer antireflective coating by a low temperature sol-gel route , 1994 .

[16]  H. Dislich,et al.  History and principles of the sol-gel process, and some new multicomponent oxide coatings , 1982 .

[17]  L. Scriven.  Physics and Applications of DIP Coating and Spin Coating , 1988 .

[18]  H. Dislich,et al.  Anti-reflecting light-scattering coatings via the sol-gel-procedure , 1986 .

[19]  P. Belleville,et al.  A new room-temperature deposition technique for optical coatings , 1994 .

[20]  Herbert Krug,et al.  Generation of wet-chemical AR coatings on plastic substrates by the use of polymerizable nanoparticles , 1997, Optics & Photonics.