Design and Flight Test of a Cable Angle Feedback Flight Control System for the RASCAL JUH-60 Helicopter

The ability of a helicopter to carry externally slung loads makes it very versatile for many civil and military operations. However, the piloted handling qualities of the helicopter are degraded by the presence of the slung load. A control system is developed that uses measurements of the slung load motions as well as conventional fuselage feedback to improve the handling qualities for hover/low speed operations. Prior research has shown a fundamental trade-off between load damping and piloted handling qualities for a feedback control system with cable angle/rate feedback. A new task tailored approach proposed and implemented herein uses a method of switching between a load damping mode and a piloted handling qualities mode. These modes provide appropriate load feedback depending on the piloting task and flight regime. This provides improved handling qualities for maneuvering flight, and for improved precision load control at hover. A new mission task element (MTE) for precision load placement is developed to test the ability of the cable feedback system to improve load placement task performance. The improvements provided by this control system are demonstrated in a piloted flight test on the JUH-60A RASCAL fly-by-wire helicopter. The average load set-down time was reduced by a factor of two for the 1000lb load on a 56ft sling.

[1]  Mark B. Tischler,et al.  A multidisciplinary flight control development environment and its application to a helicopter , 1999 .

[2]  Douglas P. Looze.  Franklin, Powell and Emami-Naeini, Feedback Control of Dynamic Systems, 6 th Edition, Prentice-Hall, 2010. (referred to as FPE) References: Ogata, Modern Control Engineering, Prentice-Hall, 2009. Dorf, Modern Control Systems, Prentice-Hall, 2008. , 2013 .

[3]  David T Liu.  In-Flight Stabilization of Externally Slung Helicopter Loads , 1973 .

[4]  J Davis,et al.  Heavy Lift Helicopter Flight Control System. Volume III. Automatic Flight Control System Development and Feasibility Demonstration , 1977 .

[5]  Morten Bisgaard,et al.  Input Shaping for Helicopter Slung Load Swing Reduction , 2008 .

[6]  Morten Bisgaard,et al.  Swing Damping for Helicopter Slung Load Systems using Delayed Feedback , 2009 .

[7]  N. K. Gupta,et al.  Automatic control of a helicopter with a hanging load. [development and evaluation of automatic pilot for use with S-61 helicopter] , 1973 .

[8]  Christina M. Ivler,et al.  Handling-Qualities Optimization and Trade-offs in Rotorcraft Flight Control Design , 2008 .

[9]  A. J. Hutto.  Flight‐Test Report on the Heavy‐Lift Helicopter Flight‐Control System , 1976 .

[10]  J. David Powell,et al.  Cable Angle Feedback Control Systems to Improve Handling Qualities for Helicopters with Slung Loads , 2011 .

[11]  John G. McGonagle.  The Design, Test, and Development Challenges of Converting the K-MAX Helicopter to a Heavy Lift Rotary Wing UAV , 2001 .

[12]  John Hodgkinson,et al.  Aircraft Handling Qualities , 1999 .

[13]  James H. Smith,et al.  Design And Flight Test Of The Active Arm External Load Stabilization System (AAELSS II) , 1976 .

[14]  J. J. Howlett.  UH-60A Black Hawk engineering simulation program. Volume 1: Mathematical model , 1981 .

[15]  Fernando,et al.  Flight Research Qualification of the Army/NASA RASCAL Variable-Stability Helicopter , 2002 .

[16]  Eric,et al.  Development of External Load Handling Qualities Criteria for Rotorcraft , 2010 .

[17]  J. Gera,et al.  A method of automatically stabilizing helicopter sling loads , 1974 .

[18]  Boeing Vertol Co.,et al.  Heavy-Lift Helicopter Flight Control System Flight Test Report , 1975 .

[19]  David G. Mitchell,et al.  Test Guide for ADS-33E-PRF , 2008 .

[20]  Brian T Fujizawa.  Control Law Design and Validation for a Helicopter In-Flight Simulator , 2010 .

[21]  T. A. Dukes.  Maneuvering Heavy Sling Loads Near Hover , 1972 .