High sensitivity, high resolution, uncalibrated phase read-out circuit for optoelectronic detection of chemical substances

Abstract In this paper, we present an uncalibrated phase read-out circuit for the detection of chemical substances through optoelectronic devices such as photodiodes and image sensors. The system, based on an automatic analogue circuit operating a phase-to-voltage conversion, shows the following main characteristics: high sensitivity and resolution, high accuracy and precision, low noise, reduced circuitry complexity (minimum required silicon area for the integration on chip), good linearity, capability of phase sign detection, independence from input signal amplitudes and waveforms, setting and zeroing of the output voltage offset and autocalibration. For these reasons, since several sensor applications need an array management performed by a single chip, the developed read-out analogue circuit can be easily integrated on a single chip together with optoelectronic devices, so it can be considered as a suitable solution for signal detection portable systems. Experimental measurements, conducted through the fabricated prototype PCB and employing a single commercial photodiode as light power sensor, have shown a high circuit sensitivity and resolution, in the three considered phase full-scales equal to ±10°, ±1° and ±0.1°, confirming the very good performances of the proposed system to reveal also very small phase shifts. The complete measurement system has been utilised to detect and quantify variations of the molar concentration of methylene blue diluted in distilled water by employing a suitable optical set-up that allowed to achieve resolutions lower than 44 pM.

[1]  Giuseppe Ferri,et al.  Analog Circuits and Systems for Voltage-Mode and Current-Mode Sensor Interfacing Applications , 2011 .

[2]  Jürgen Schumacher,et al.  Device physics of silicon solar cells , 2001 .

[3]  G. Ferri,et al.  An integrated analog lock-in amplifier for low-voltage low-frequency sensor interface , 2007, 2007 2nd International Workshop on Advances in Sensors and Interface.

[4]  Robert Puers,et al.  A flexible system-on-chip (SoC) for biomedical signal acquisition and processing , 2006 .

[5]  Vincenzo Stornelli,et al.  A New and Fast-Readout Interface for Resistive Chemical Sensors , 2010, IEEE Transactions on Instrumentation and Measurement.

[6]  A. Hierlemann,et al.  A Smart Single-Chip Micro-Hotplate-Based Gas Sensor System in CMOS-Technology , 2004 .

[7]  A. Yariv.  Optical electronics in modern communications , 1997 .

[8]  A. Flammini,et al.  Uncalibrated integrable wide-range single-supply portable interface for resistance and parasitic capacitance determination , 2008 .

[9]  M. L. Meade.  Lock-in amplifiers : principles and applications , 1983 .

[10]  Pisana Placidi,et al.  A System for the Dynamic Control and Thermal Characterization of Ultra Low Power Gas Sensors , 2011, IEEE Transactions on Instrumentation and Measurement.

[11]  A. Simoni,et al.  A High Dynamic Range CMOS Interface for Resistive Gas Sensor Array with Gradient Temperature Control , 2006, 2006 IEEE Instrumentation and Measurement Technology Conference Proceedings.

[12]  Wolfgang Trettnak,et al.  Miniaturized luminescence lifetime-based oxygen sensor instrumentation utilizing a phase modulation technique , 1996 .

[13]  Robin Bargar,et al.  Circuits for voltage tuning the parameters of Chua's circuit: Experimental application for musical signal generation , 1994 .

[14]  C. Hagleitner,et al.  CMOS Monolithic Metal–Oxide Gas Sensor Microsystems , 2006, IEEE Sensors Journal.

[15]  Christofer Toumazou,et al.  A 1 V Wireless Transceiver for an Ultra-Low-Power SoC for Biotelemetry Applications , 2008, IEEE Journal of Solid-State Circuits.

[16]  E. Martinelli,et al.  A Fully-Analog Lock-In Amplifier With Automatic Phase Alignment for Accurate Measurements of ppb Gas Concentrations , 2012, IEEE Sensors Journal.

[17]  Wolf-Joachim Fischer,et al.  Integration of a wireless lock-in measurement of hip prosthesis vibrations for loosening detection , 2009 .

[18]  Vincenzo Stornelli,et al.  Low-voltage low-power integrated analog lock-in amplifier for gas sensor applications , 2010 .

[19]  A. Titus,et al.  CMOS mixed-signal phase detector for integrated chemical sensor systems , 2005, IEEE Sensors, 2005..

[20]  Vincenzo Stornelli,et al.  Novel CMOS fully integrable interface for wide-range resistive sensor arrays with parasitic capacitance estimation , 2008 .

[21]  Antonio Gnudi,et al.  Integrated lock–in amplifier for sensor applications , 1999 .

[22]  Andrea De Marcellis,et al.  A Novel Analog Autocalibrating Phase-Voltage Converter for Signal Phase-Shifting Detection , 2011, IEEE Sensors Journal.

[23]  Vincenzo Stornelli,et al.  A single-chip integrated interfacing circuit for wide-range resistive gas sensor arrays , 2009 .

[24]  Albert H. Titus,et al.  CMOS integrated optical sensor using phase detection , 2003, Proceedings of IEEE Sensors 2003 (IEEE Cat. No.03CH37498).

[25]  M. O. Sonnaillon,et al.  A low-cost, high-performance, digital signal processor-based lock-in amplifier capable of measuring multiple frequency sweeps simultaneously , 2005 .

[26]  A. Fort,et al.  Electronic noses based on metal oxide gas sensors: the problem of selectivity enhancement , 2004, Proceedings of the 21st IEEE Instrumentation and Measurement Technology Conference (IEEE Cat. No.04CH37510).

[27]  Oliver Brand,et al.  A CMOS-based integrated-system architecture for a static cantilever array , 2008 .

[28]  Vincenzo Stornelli,et al.  Current-Mode High-Accuracy High-Precision CMOS Amplifiers , 2008, IEEE Transactions on Circuits and Systems II: Express Briefs.

[29]  G. Ferri,et al.  Uncalibrated Analog Bridge-Based Interface for Wide-Range Resistive Sensor Estimation , 2012, IEEE Sensors Journal.

[30]  Johan H. Huijsing,et al.  Integrated smart sensors , 1992 .

[31]  S. M. Sze,et al.  Physics of semiconductor devices , 1969 .

[32]  Giuseppe Ferri,et al.  A low-voltage integrated CMOS analog lock-in amplifier prototype for LAPS applications , 2001 .

[33]  Vincenzo Stornelli,et al.  A CMOS Integrable Oscillator-Based Front End for High-Dynamic-Range Resistive Sensors , 2008, IEEE Transactions on Instrumentation and Measurement.

[34]  Edoardo Franzi,et al.  Interface circuit for metal-oxide gas sensor , 2001, Proceedings of the IEEE 2001 Custom Integrated Circuits Conference (Cat. No.01CH37169).

[35]  Jong-Kee Kwon,et al.  A Low-Power, Wide-Dynamic-Range Semi-Digital Universal Sensor Readout Circuit Using Pulsewidth Modulation , 2011, IEEE Sensors Journal.

[36]  Giovanni Chiorboli,et al.  Integrated lock-in amplifier for contactless interface to magnetically stimulated mechanical resonators , 2008, 2008 3rd International Conference on Design and Technology of Integrated Systems in Nanoscale Era.

[37]  G. Ferri,et al.  A CCII-Based Low-Voltage Low-Power Read-Out Circuit for DC-Excited Resistive Gas Sensors , 2009, IEEE Sensors Journal.