Sludge filterability and dewaterability in a membrane bioreactor for municipal wastewater treatment

Abstract The physical properties of excess sludge wasted from a large pilot scale membrane bioreactor (MBR) have been routinely monitored over almost two years. A statistical analysis highlighted the significant impact of temperature on the capillary suction time and sludge filterability, due to the increase of organic matter in the liquid phase. Suspended solids have resulted to be the most important component affecting sludge filterability, although the impact of colloids and solutes increased when temperature decrease, thus confirming the generally worse characteristics of sludge in such conditions. Conditioning and dewatering test have been performed on a pilot scale fixed volume recessed plate filter press. Six different chemicals were used for sludge pre-conditioning and, for each additive, three dosages were tested in the range 5–25 gpolymer kgMLSS− 1. After about sixty filtration trials at three different pressure values (7, 11 and 15 bar), the kind of polymer seem to be the most important factor influencing the final cake-dryness, with less evident impact for dosage and operational pressure. Finally, when performed on the aerobically digested excess sludge wasted from a conventional activated sludge plant, the filtration tests show no differences with the MBR sludge.

[1]  Xiao-yan Li,et al.  Hydrodynamics of biological aggregates of different sludge ages: an insight into the mass transport mechanisms of bioaggregates. , 2003, Environmental science & technology.

[2]  El Hani Bouhabila,et al.  Microfiltration of activated sludge using submerged membrane with air bubbling (application to wastewater treatment) , 1998 .

[3]  Christelle Wisniewski,et al.  Physical properties of activated sludge in a submerged membrane bioreactor and relation with membrane fouling , 2007 .

[4]  T. Arnot,et al.  In situ manipulation of critical flux in a submerged membrane bioreactor using variable aeration rates, and effects of membrane history , 2004 .

[5]  Thomas Wintgens,et al.  The importance of liquid phase analyses to understand fouling in membrane assisted activated sludge processes—six case studies of different European research groups , 2005 .

[6]  George Tchobanoglous,et al.  Wastewater Engineering Treatment and Reuse ( Fourth Edition ) , 2011 .

[7]  F. Fan,et al.  Identification of wastewater sludge characteristics to predict critical flux for membrane bioreactor processes. , 2006, Water research.

[8]  Gianni Andreottola,et al.  Sub-critical fouling in a membrane bioreactor for municipal wastewater treatment: experimental investigation and mathematical modelling. , 2007, Water research.

[9]  G Amy,et al.  Impact of colloidal and soluble organic material on membrane performance in membrane bioreactors for municipal wastewater treatment. , 2006, Water research.

[10]  G. G. Stokes.  "J." , 1890, The New Yale Book of Quotations.

[11]  H. D. Stensel,et al.  Wastewater Engineering: Treatment and Reuse , 2002 .

[12]  Gianni Andreottola,et al.  Flux criticality and sustainability in a hollow fibre submerged membrane bioreactor for municipal wastewater treatment , 2007 .

[13]  Matthias Kraume,et al.  Rheology of Activated Sludge in Membrane Bioreactors , 2002 .

[14]  Giorgio Mannina,et al.  An integrated model for physical-biological wastewater organic removal in a submerged membrane bioreactor: Model development and parameter estimation , 2008 .

[15]  Ann R. Cannon.  Essential Statistics , 2001 .

[16]  Guowei Gu,et al.  Sludge rheological and physiological characteristics in a pilot-scale submerged membrane bioreactor , 2007 .

[17]  Fenglin Yang,et al.  A comprehensive study on membrane fouling in submerged membrane bioreactors operated under different aeration intensities , 2008 .

[18]  C. Brepols,et al.  Modelling of a membrane bioreactor system for municipal wastewater treatment , 2003 .

[19]  G. Vetrovec.  DES , 2021, Encyclopedia of Systems and Control.

[20]  Yasutoshi Shimizu,et al.  Filtration characteristics of hollow fiber microfiltration membranes used in membrane bioreactor for domestic wastewater treatment , 1996 .

[21]  H. Nagaoka,et al.  Influence of bacterial extracellular polymers on the membrane separation activated sludge process , 1996 .

[22]  M. Spérandio,et al.  Modelling an aerobic submerged membrane bioreactor with ASM models on a large range of sludge retention time , 2008 .

[23]  Sara Arabi,et al.  Impact of protein/carbohydrate ratio in the feed wastewater on the membrane fouling in membrane bioreactors , 2008 .

[24]  Sungpyo Hong,et al.  Fouling control in activated sludge submerged hollow fiber membrane bioreactors , 2002 .

[25]  A Pollice,et al.  Physical characteristics of the sludge in a complete retention membrane bioreactor. , 2007, Water research.

[26]  Thomas Melin,et al.  Long-term monitoring of a full-scale municipal membrane bioreactor—Characterisation of foulants and operational performance , 2008 .

[27]  Jun-Young Kim,et al.  Membrane fouling control through the change of the depth of a membrane module in a submerged membrane bioreactor for advanced wastewater treatment , 2008 .