Effect of alloying elements on the contact resistance and the passivation behaviour of stainless steels

Abstract The effects of alloying elements (Cr, Mo) on the passivation and the transpassive transition behaviour of various commercial stainless steels, which are candidate materials for the bi-polar plates in polymer electrolyte membrane fuel cell, were investigated via a contact electric resistance (CER) technique with graphite counter part. The contact resistance, too high for a semi-conductor film with high donor density, is not the inherent ohmic resistance of the passive film. The CER potentials decrease linearly with the pitting resistance equivalent number (PREN). The passive films of stainless steels with high PREN are more readily removed compared to those with low PREN in terms of the charge necessary to remove the passive films. The change in transpassive transition behaviour of the stainless steels from that of iron to that of chromium went on steeply with an increase in the PREN.

[1]  P. Schmuki,et al.  Transpassive Dissolution of Cr and Sputter‐Deposited Cr Oxides Studied by In Situ X‐Ray Near‐Edge Spectroscopy , 1996 .

[2]  K. Asami,et al.  An XPS study of the passivity of a series of iron—chromium alloys in sulphuric acid*† , 1978 .

[3]  Iva Betova,et al.  Passivation mechanism of iron in concentrated phosphoric acid , 1999 .

[4]  K. Sugimoto,et al.  The role of molybdenum additions to austenitic stainless steels in the inhibition of pitting in acid chloride solutions , 1977 .

[5]  Supramaniam Srinivasan,et al.  High performance proton exchange membrane fuel cells with sputter-deposited Pt layer electrodes , 1997 .

[6]  C. Chamberlin,et al.  Modeling of Proton Exchange Membrane Fuel Cell Performance with an Empirical Equation , 1995 .

[7]  M. Pourbaix.  Atlas of Electrochemical Equilibria in Aqueous Solutions , 1974 .

[8]  Wilson,et al.  Corrosion Testing of Stainless Steel Fuel Cell Hardware , 1998 .

[9]  S. Piazza,et al.  Photocurrent Spectroscopic Investigations of Passive Films on Chromium , 1990 .

[10]  J. R. Vilche,et al.  Investigation of passive layers on iron and iron-chromium alloys by electrochemical impedance spectroscopy , 1993 .

[11]  H. Engell,et al.  The anodic polarization curves of iron-nickel-chromium alloys , 1966 .

[12]  M. Lazzarino,et al.  Improved contact resistance to n-type wide gap II–VI semiconductors , 1996 .

[13]  H. Kwon,et al.  Effects of Tungsten on Corrosion and Kinetics of Sigma Phase Formation of 25% Chromium Duplex Stainless Steels , 1999 .

[14]  H. Uhlig,et al.  Critical Potentials for Pitting Corrosion of Ni, Cr‐Ni, Cr‐Fe, and Related Stainless Steels , 1968 .

[15]  H. Strehblow,et al.  A combined surface analytical and electrochemical study of the formation of passive layers on alloys in 0.5 M H2SO4 , 1995 .