Experimental Study on Effect of Operating Conditions on Thermoelectric Power Generation

Abstract Effect of boundary conditions of thermal reservoirs on power generation of thermoelectric modules (TEMs) is examined experimentally. To realize the characteristics of the power generation by the TEMs, the system performance is studied over various volumetric flow rates and flow temperatures of the hot gas and in the heat sink over a wide range of electrical load. The results show a significant influence of forced convection produced by an axial fan in the heat sink in comparison with natural convection. Also, both of the temperature and volumetric flow rate of the hot gas have a substantial effect on power generation by the TEMs. Lower volumetric flow rate in the heat sink is suggested to save fan power because it is found that higher volumetric flow rates on the cold side after the optimal flow rate does not have much effect on the power generation by TEMs. The maximum power produced by tested TEMs is 4.59 W at temperature difference equal to 133.78°C.

[1]  Aliakbar Akbarzadeh,et al.  Performance and reliability of commercially available thermoelectric cells for power generation , 2016 .

[2]  Shixue Wang,et al.  Theoretical analysis of a thermoelectric generator using exhaust gas of vehicles as heat source , 2013 .

[3]  Cheng-Ting Hsu,et al.  Experiments and simulations on low-temperature waste heat harvesting system by thermoelectric power generators , 2011 .

[4]  Wei-Hsin Chen,et al.  Experimental study on thermoelectric modules for power generation at various operating conditions , 2012 .

[5]  Matteo Chiesa,et al.  Modeling and optimization of solar thermoelectric generators for terrestrial applications , 2012 .

[6]  Á.G. Miranda,et al.  Feasibility study of a green energy powered thermoelectric chip based air conditioner for electric vehicles , 2013 .

[7]  Gequn Shu,et al.  Power and efficiency factors for comprehensive evaluation of thermoelectric generator materials , 2016 .

[8]  Wei-Chin Chang,et al.  A mathematic model of thermoelectric module with applications on waste heat recovery from automobile engine , 2010 .

[9]  Gequn Shu,et al.  A comprehensive design method for segmented thermoelectric generator , 2015 .

[10]  Ali Shakouri,et al.  Co-optimized design of microchannel heat exchangers and thermoelectric generators , 2013 .

[11]  Lasse Rosendahl,et al.  A comparison of micro-structured flat-plate and cross-cut heat sinks for thermoelectric generation application , 2015 .

[12]  Gequn Shu,et al.  Effect of vehicle driving conditions on the performance of thermoelectric generator , 2015 .