An Integrated Multimodal Knee Brace Enabling Mid-Activity Tracking for Joint Health Assessment

Developments in wearable technologies created opportunities for non-invasive joint health assessment while subjects perform daily activities during rehabilitation and recovery. However, existing state-of-art solutions still require a health professional or a researcher to set up the device, and most of them are not convenient for at-home use. In this paper, we demonstrate the latest version of the multimodal knee brace that our lab previously developed. This knee brace utilizes four sensing modalities: joint acoustic emissions (JAEs), electrical bioimpedance (EBI), activity and temperature. We designed custom printed-circuit boards and developed firmware to acquire high quality data. For the brace material, we used a commercial knee brace and modified it for the comfort of patients as well as to secure all electrical connections. We updated the electronics to enable rapid EBI measurements for mid-activity tracking. The performance of the multimodal knee brace was evaluated through a proof-of-concept human subjects study (n=9) with 2 days of measurement and 3 sessions per day. We obtained consistent EBI data with less than 1 Ω variance in measured impedance within six full frequency sweeps (each sweep is from 5 kHz to 100 kHz with 256 frequency steps) from each subject. Then, we asked subjects to perform 10 unloaded knee flexion/extensions, while we measured continuous 5 kHz and 100 kHz EBI at every 100 ms. The ratio of the range of reactance (ΔX5kHz/ΔX100kHz) was found to be less than 1 for all subjects for all cycles, which indicates lack of swelling and thereby a healthy joint. We also conducted intra and inter session reliability analysis for JAE recordings through intraclass correlation analysis (ICC), and obtained excellent ICC values (>0.75), suggesting reliable performance on JAE measurements. The presented knee brace could readily be used at home in future work for knee health monitoring of patients undergoing rehabilitation or recovery.

[1]  Caitlin N. Teague,et al.  A Wearable, Multimodal Sensing System to Monitor Knee Joint Health , 2020, IEEE Sensors Journal.

[2]  Pascal Fua,et al.  Estimation and visualization of sagittal kinematics of lower limbs orientation using body-fixed sensors , 2006, IEEE Transactions on Biomedical Engineering.

[3]  J W Katz,et al.  The diagnostic accuracy of ruptures of the anterior cruciate ligament comparing the Lachman test, the anterior drawer sign, and the pivot shift test in acute and chronic knee injuries , 1986, The American journal of sports medicine.

[4]  Geza F. Kogler,et al.  Acoustic Emissions as a Non-invasive Biomarker of the Structural Health of the Knee , 2019, Annals of Biomedical Engineering.

[5]  Hakan Toreyin,et al.  Wearable Vector Electrical Bioimpedance System to Assess Knee Joint Health , 2017, IEEE Transactions on Biomedical Engineering.

[6]  M. Hunink,et al.  MRI for traumatic knee injury: a review. , 2007, Seminars in ultrasound, CT, and MR.

[7]  Asim H. Gazi,et al.  An Interpretable Experimental Data Augmentation Method to Improve Knee Health Classification Using Joint Acoustic Emissions , 2021, Annals of Biomedical Engineering.

[8]  S Totterman,et al.  The acutely ACL injured knee assessed by MRI: are large volume traumatic bone marrow lesions a sign of severe compression injury? , 2008, Osteoarthritis and cartilage.

[9]  M. Englund,et al.  Arthroscopy for degenerative knee—a difficult habit to break? , 2014, Acta orthopaedica.

[10]  Thomas Seel,et al.  IMU-Based Joint Angle Measurement for Gait Analysis , 2014, Sensors.

[11]  Daniel C. Whittingslow,et al.  Detection of Meniscal Tear Effects on Tibial Vibration Using Passive Knee Sound Measurements , 2021, IEEE Transactions on Biomedical Engineering.

[12]  Rezvan Kianifar,et al.  Automated Assessment of Dynamic Knee Valgus and Risk of Knee Injury During the Single Leg Squat , 2017, IEEE Journal of Translational Engineering in Health and Medicine.

[13]  J. Fleiss.  The design and analysis of clinical experiments , 1987 .

[14]  Mohsen Safaei,et al.  A Novel Accelerometer Mounting Method for Sensing Performance Improvement in Acoustic Measurements From the Knee. , 2020, Journal of vibration and acoustics.

[15]  Daniel Whittingslow,et al.  Robust Method for Mid-Activity Tracking and Evaluation of Ankle Health Post-Injury , 2020, IEEE Transactions on Biomedical Engineering.

[16]  Leia Stirling,et al.  An Auto-Calibrating Knee Flexion-Extension Axis Estimator Using Principal Component Analysis with Inertial Sensors , 2018, Sensors.

[17]  Daniel Whittingslow,et al.  Robust Longitudinal Ankle Edema Assessment Using Wearable Bioimpedance Spectroscopy , 2020, IEEE Transactions on Biomedical Engineering.