Determination of the effective thermal diffusivity of nanofluids by the double hot-wire technique

This paper introduces a new transient double hot-wire technique for the direct measurement of the thermal diffusivity of nanofluids. A correlation to be used with the double hot-wire technique to calculate the effective thermal diffusivity of nanofluids is also developed. Several types of nanofluids were prepared by suspending different volume percentages (1–5%) of titanium dioxide (TiO2), aluminium oxide (Al2O3) and aluminium (Al) nanoparticles in ethylene glycol and engine oil. The thermal diffusivities of these nanofluids determined directly by this technique were found to increase substantially with the increased volume fraction of nanoparticles in base fluids. Based on the calibration results obtained for the base fluids, ethylene glycol and engine oil, the measurement error is estimated to be within 1.2%. The measured thermal diffusivities of nanofluids were found to be significantly higher than those calculated from the thermal diffusivity expression (i.e. αeff = keff/(ρ cp)eff) by using the effective thermal conductivities and volumetric specific heats obtained from the conventional hot-wire method and from the volume fraction mixture rule, respectively.

[1]  W. Roetzel,et al.  Temperature oscillation techniques for simultaneous measurement of thermal diffusivity and conductivity , 1995 .

[2]  Stephen U. S. Choi,et al.  Role of Brownian motion in the enhanced thermal conductivity of nanofluids , 2004 .

[3]  J P Bentley,et al.  Temperature sensor characteristics and measurement system design , 1984 .

[4]  K. Leong,et al.  A MODEL FOR PREDICTING THE EFFECTIVE THERMAL CONDUCTIVITY OF NANOPARTICLE-FLUID SUSPENSIONS , 2006 .

[5]  S. Phillpot,et al.  THERMAL TRANSPORT IN NANOFLUIDS1 , 2004 .

[6]  B. Wang,et al.  Viscosity, thermal diffusivity and Prandtl number of nanoparticle suspensions , 2004 .

[7]  Y. Xuan,et al.  Investigation on Convective Heat Transfer and Flow Features of Nanofluids , 2003 .

[8]  J. W. Haarman.  A contribution to the theory of the transient hot-wire method , 1971 .

[9]  J. Eastman,et al.  Measuring Thermal Conductivity of Fluids Containing Oxide Nanoparticles , 1999 .

[10]  W. Roetzel,et al.  Conceptions for heat transfer correlation of nanofluids , 2000 .

[11]  Kenneth D. Kihm,et al.  Thermal Conductivity Enhancement of Nanofluids by Brownian Motion , 2005 .

[12]  A. Mandelis,et al.  Simple, accurate, and precise measurements of thermal diffusivity in liquids using a thermal-wave cavity , 2001 .

[13]  R. J. Jenkins,et al.  Flash Method of Determining Thermal Diffusivity, Heat Capacity, and Thermal Conductivity , 1961 .

[14]  A. Nagashima,et al.  Simultaneous measurement of the thermal conductivity and the thermal diffusivity of liquids by the transient hot‐wire method , 1981 .

[15]  M. F. Torchio,et al.  Two-Wire Solution for Measurement of the Thermal Conductivity and Specific Heat Capacity of Liquids: Experimental Design , 2004 .

[16]  Huaqing Xie,et al.  Thermal conductivity enhancement of suspensions containing nanosized alumina particles , 2002 .

[17]  K. Leong,et al.  A model for the thermal conductivity of nanofluids – the effect of interfacial layer , 2006 .

[18]  K. Leong,et al.  Enhanced thermal conductivity of TiO2—water based nanofluids , 2005 .

[19]  O. K. Crosser,et al.  Thermal Conductivity of Heterogeneous Two-Component Systems , 1962 .

[20]  Pak Ming Hui,et al.  Thermal conductivity of graded composites: Numerical simulations and an effective medium approximation , 1999 .

[21]  H. H. Steinour,et al.  Rate of sedimentation.Nonflocculated Suspensions of Uniform Spheres , 1944 .

[22]  Günter Kargl,et al.  A NEW METHOD FOR THE DETERMINATION OF THERMAL CONDUCTIVITY AND THERMAL DIFFUSIVITY FROM LINEAR HEAT SOURCE MEASUREMENTS , 1997 .