Flow pattern, void fraction and pressure drop of two-phase air–water flow in a horizontal circular micro-channel

Abstract Adiabatic two-phase air–water flow characteristics, including the two-phase flow pattern as well as the void fraction and two-phase frictional pressure drop, in a circular micro-channel are experimentally studied. A fused silica channel, 320 mm long, with an inside diameter of 0.53 mm is used as the test section. The test runs are done at superficial velocity of gas and liquid ranging between 0.37–16 and 0.005–3.04 m/s, respectively. The flow pattern map is developed from the observed flow patterns i.e. slug flow, throat-annular flow, churn flow and annular-rivulet flow. The flow pattern map is compared with those of other researchers obtained from different working fluids. The present single-phase experiments also show that there are no significant differences in the data from the use of air or nitrogen gas, and water or de-ionized water. The void fraction data obtained by image analysis tends to correspond with the homogeneous flow model. The two-phase pressure drops are also used to calculate the frictional multiplier. The multiplier data show a dependence on flow pattern as well as mass flux. A new correlation of two-phase frictional multiplier is also proposed for practical application.

[1]  Pei-Xue Jiang,et al.  Thermal hydraulic performance of small scale micro-channel and porous-media heat-exchangers , 2001 .

[2]  D. Chisholm.  A theoretical basis for the Lockhart-Martinelli correlation for two-phase flow , 1967 .

[3]  Said I. Abdel-Khalik,et al.  Gas–liquid two-phase flow in microchannels: Part II: void fraction and pressure drop , 1999 .

[4]  Somchai Wongwises,et al.  Two-phase flow pattern maps for vertical upward gas-liquid flow in mini-gap channels , 2004 .

[5]  Mikio Suo,et al.  Two phase flow in capillary tubes , 1964 .

[6]  Chin Pan,et al.  Gas-liquid two-phase flow in micro-channels , 2002 .

[7]  Chin Pan,et al.  Ethanol–CO2 two-phase flow in diverging and converging microchannels , 2005 .

[8]  T. Karayiannis,et al.  Flow boiling and flow regimes in small diameter tubes , 2004 .

[9]  R. Shah,et al.  Fluid Flow and Heat Transfer at Micro- and Meso-Scales With Application to Heat Exchanger Design , 2000 .

[10]  S. McPhail,et al.  Experimental study on compressible flow in microtubes , 2007 .

[11]  Said I. Abdel-Khalik,et al.  Gas–liquid two-phase flow in microchannels Part I: two-phase flow patterns , 1999 .

[12]  Philipp Rudolf von Rohr,et al.  Two-phase flow characteristics in gas–liquid microreactors , 2006 .

[13]  K. S. Rezkallah,et al.  Gas-liquid flow patterns at microgravity conditions , 1993 .

[14]  R. Panton,et al.  The effects of contact angle on two-phase flow in capillary tubes , 1993 .

[15]  R. Lockhart.  Proposed Correlation of Data for Isothermal Two-Phase, Two-Component Flow in Pipes , 1949 .

[16]  Tohru Fukano,et al.  Characteristics of gas-liquid two-phase flow in a capillary tube , 1993 .

[17]  Ziping Feng,et al.  Two-phase flow in microchannels , 2002 .

[18]  Akimaro Kawahara,et al.  Two-Phase Flow Through Square and Circular Microchannels—Effects of Channel Geometry , 2004 .

[19]  Satish G. Kandlikar,et al.  Fundamental issues related to flow boiling in minichannels and microchannels , 2002 .

[20]  Somchai Wongwises,et al.  Flow pattern, pressure drop and void fraction of two-phase gas–liquid flow in an inclined narrow annular channel , 2006 .

[21]  Neima Brauner,et al.  Identification of the range of ‘small diameters’ conduits, regarding two-phase flow pattern transitions , 1992 .

[22]  A. Serizawa.  Two-Phase Flow in Micro-Channels , 2002 .

[23]  Masahiro Kawaji,et al.  The effect of channel diameter on adiabatic two-phase flow characteristics in microchannels ☆ , 2004 .

[24]  A. Kawahara,et al.  Investigation of two-phase flow pattern, void fraction and pressure drop in a microchannel , 2002 .