Complete Design and Measurement Methodology for a Tunable RF Impedance-Matching Network

This paper presents the design, fabrication, and characterization of a compact narrowband tunable impedance-matching network. A prototype was fabricated in hybrid technology using coplanar waveguide transmission lines and surface-mounted components. The network consists of a II-structure with tunable components made of varactors in series with inductors. Simulations and measurements are in good agreement. A new measurement methodology suitable for tunable impedance-matching networks is proposed. The results show that complex impedances with magnitudes varying from 6 Omega to 1 kOmega can be matched at 1 GHz and tuned in a 50% bandwidth. In addition, nonlinear measurements were done to fully characterize the network. The 1-dB compression point is reached at an input power of 20 dBm, while the input power for the third-order intermodulation intercept point is 21.3 dBm for a 1-kHz offset between the two input frequencies.

[1]  Tauno Vähä-Heikkilä,et al.  On-wafer noise-parameter measurements at W-band , 2003 .

[2]  R. Q. Lee,et al.  Impedance matching of tapered slot antenna using a dielectric transformer , 1998 .

[3]  P. Ferrari,et al.  A RF tunable impedance matching network with a complete design and measurement methodology , 2007, 2007 European Microwave Conference.

[4]  N.S. Barker,et al.  Distributed MEMS tunable matching network using minimal-contact RF-MEMS varactors , 2006, IEEE Transactions on Microwave Theory and Techniques.

[5]  Georg Fischer,et al.  RF-MEMS and SiC/GaN as enabling technologies for a reconfigurable multi-band/multi-standard radio , 2003, Bell Labs Technical Journal.

[6]  R.A. York,et al.  Analog tunable matching network using integrated thin-film BST capacitors , 2004, 2004 IEEE MTT-S International Microwave Symposium Digest (IEEE Cat. No.04CH37535).

[7]  P. Garcia,et al.  An RF electronically controlled impedance tuning network design and its application to an antenna input impedance automatic matching system , 2004, IEEE Transactions on Microwave Theory and Techniques.

[8]  J.H. Sinsky,et al.  Design of an electronically tunable microwave impedance transformer , 1997, 1997 IEEE MTT-S International Microwave Symposium Digest.

[9]  R. Weigel,et al.  A comparison of tunable ferroelectric Π- and T-matching networks , 2007, 2007 European Microwave Conference.

[10]  A. Tombak.  A Ferroelectric-Capacitor-Based Tunable Matching Network for Quad-Band Cellular Power Amplifiers , 2007, IEEE Transactions on Microwave Theory and Techniques.

[11]  A. Akhnoukh,et al.  Adaptive Multi-Band Multi-Mode Power Amplifier Using Integrated Varactor-Based Tunable Matching Networks , 2006, IEEE Journal of Solid-State Circuits.

[12]  Philippe Ferrari,et al.  Design of an ultra compact electronically tunable microwave impedance transformer , 2005 .

[13]  Hiroshi Hataoka,et al.  Investigation of Intermodulation in a Tuning Varactor , 1983, IEEE Transactions on Broadcasting.

[14]  R. D. Pollard,et al.  A novel MMIC source impedance tuner for on-wafer microwave noise parameter measurements , 1996 .

[15]  Dylan F. Williams,et al.  A General Waveguide Circuit Theory , 1992, Journal of research of the National Institute of Standards and Technology.

[16]  Thomas J. Brazil,et al.  A Large-Signal Equivalent Circuit Model for Hyperabrupt P-N Junction Varactor Diodes , 1992, 1992 22nd European Microwave Conference.

[17]  Philippe Ferrari,et al.  Tapered distributed analogue tunable phase shifter with low insertion and return loss , 2005 .

[18]  Arda D. Yalcinkaya,et al.  High aspect ratio MEMS capacitor for high frequency impedance matching applications , 2003, 10th IEEE International Conference on Electronics, Circuits and Systems, 2003. ICECS 2003. Proceedings of the 2003.

[19]  B. Huyart,et al.  MMIC impedance matching system , 2000 .

[20]  W. Bischof,et al.  Variable impedance tuner for MMIC's , 1994, IEEE Microwave and Guided Wave Letters.

[21]  V. Nerguizian,et al.  A compact size reconfigurable 1-3 GHz impedance tuner suitable for RF MEMS applications , 2004, Proceedings. The 16th International Conference on Microelectronics, 2004. ICM 2004..

[22]  K.L. Melde,et al.  Reconfigurable RF impedance tuner for match control in broadband wireless devices , 2006, IEEE Transactions on Antennas and Propagation.

[23]  John Papapolymerou,et al.  Reconfigurable double-stub tuners using MEMS switches for intelligent RF front-ends , 2003 .

[24]  Youngwoo Kwon,et al.  Low-loss analog and digital micromachined impedance tuners at the Ka-band , 2001 .

[25]  Huai Gao,et al.  Broad-band power amplifier with a novel tunable output matching network , 2005, IEEE Transactions on Microwave Theory and Techniques.

[26]  P. Ferrari,et al.  Accurate measurement method for characterisation of RF impedance tuners , 2007 .

[27]  G.M. Rebeiz,et al.  W-band RF MEMS double and triple-stub impedance tuners , 2005, IEEE MTT-S International Microwave Symposium Digest, 2005..

[28]  Jia-Sheng Hong,et al.  VARIABLE ZC TRANSMISSION LINE AND ITS APPLICATION TO AN IMPEDANCE TRANSFORMER , 2005 .

[29]  R. Jakoby,et al.  Continuously tunable impedance matching network using ferroelectric varactors , 2005, IEEE MTT-S International Microwave Symposium Digest, 2005..

[30]  Robert E. Miles,et al.  A novel MMIC source impedance tuner for on-wafer microwave noise parameter measurements , 1996, IEEE 1996 Microwave and Millimeter-Wave Monolithic Circuits Symposium. Digest of Papers.

[31]  D. Peroulis,et al.  High-power MEMS varactors and impedance tuners for millimeter-wave applications , 2005, IEEE Transactions on Microwave Theory and Techniques.

[32]  Hyeong Tae Jeong,et al.  Tunable impedance transformer using a transmission line with variable characteristic impedance , 2005, IEEE Transactions on Microwave Theory and Techniques.