Health monitoring sensor placement optimization based on initial sensor layout using improved partheno-genetic algorithm

Optimal sensor placement is an important component of a reliability structural health monitoring system for a large-scale complex structure. However, the current research mainly focuses on optimizing sensor placement problem for structures without any initial sensor layout. In some cases, the experienced engineers will first determine the key position of whole structure must place sensors, that is, initial sensor layout. Moreover, current genetic algorithm or partheno-genetic algorithm will change the position of the initial sensor locations in the iterative process, so it is unadaptable for optimal sensor placement problem based on initial sensor layout. In this article, an optimal sensor placement method based on initial sensor layout using improved partheno-genetic algorithm is proposed. First, some improved genetic operations of partheno-genetic algorithm for sensor placement optimization with initial sensor layout are presented, such as segmented swap, reverse and insert operator to avoid the change of initial sensor locations. Then, the objective function for optimal sensor placement problem is presented based on modal assurance criterion, modal energy criterion, and sensor placement cost. At last, the effectiveness and reliability of the proposed method are validated by a numerical example of a quayside container crane. Furthermore, the sensor placement result with the proposed method is better than that with effective independence method without initial sensor layout and the traditional partheno-genetic algorithm.

[1]  Costas Papadimitriou,et al.  Optimal sensor placement methodology for parametric identification of structural systems , 2004 .

[2]  Ting-Hua Yi,et al.  Sensor placement on Canton Tower for health monitoring using asynchronous-climb monkey algorithm , 2012 .

[3]  Li Maojun,et al.  A PARTHENO GENETIC ALGORITHM AND ANALYSIS ON ITS GLOBAL CONVERGENCE , 1999 .

[4]  Randall J. Allemang,et al.  A Correlation Coefficient for Modal Vector Analysis , 1982 .

[5]  Guilherme Ferreira Gomes,et al.  Sensor placement optimization applied to laminated composite plates under vibration , 2018 .

[6]  Marina Schroder,et al.  Structural Control Past Present And Future , 2016 .

[7]  An-Pan Cherng OPTIMAL SENSOR PLACEMENT FOR MODAL PARAMETER IDENTIFICATION USING SIGNAL SUBSPACE CORRELATION TECHNIQUES , 1999 .

[8]  Abolfazl Toroghi Haghighat,et al.  Energy-aware framework with Markov chain-based parallel simulated annealing algorithm for dynamic management of virtual machines in cloud data centers , 2017, The Journal of Supercomputing.

[9]  L. L. Zhang,et al.  Optimal placement of sensors for structural health monitoring using improved genetic algorithms , 2004 .

[10]  Martin Hromcik,et al.  Optimal sensors placement and spillover suppression , 2012 .

[11]  Chen Yang,et al.  Optimal sensor placement for deployable antenna module health monitoring in SSPS using genetic algorithm , 2017 .

[12]  Shamim N. Pakzad,et al.  Optimal sensor configuration for flexible structures with multi-dimensional mode shapes , 2015 .

[13]  Keith Worden,et al.  Optimal sensor placement for fault detection , 2001 .

[14]  Asan Gani Abdul Muthalif,et al.  Ant Colony Optimization for Controller and Sensor-Actuator Location in Active Vibration Control , 2013 .

[15]  Debabrata Chakraborty,et al.  Genetic algorithm based optimal design for vibration control of composite shell structures using piezoelectric sensors and actuators , 2008 .

[16]  Shamim N. Pakzad,et al.  Optimal Sensor Placement for Modal Identification of Bridge Systems Considering Number of Sensing Nodes , 2014 .

[17]  D. Kammer Sensor Placement for On-Orbit Modal Identification and Correlation of Large Space Structures , 1990, 1990 American Control Conference.

[18]  Junjie Li,et al.  Virus coevolution partheno-genetic algorithms for optimal sensor placement , 2008, Adv. Eng. Informatics.

[19]  F. Udwadia Methodology for Optimum Sensor Locations for Parameter Identification in Dynamic Systems , 1994 .

[20]  Qi Xia,et al.  Genetic algorithm based optimal sensor placement for L1‐regularized damage detection , 2018, Structural Control and Health Monitoring.

[21]  A. Rama Mohan Rao,et al.  Optimal placement of sensors for structural system identification and health monitoring using a hybrid swarm intelligence technique , 2007 .

[22]  Ting-Hua Yi,et al.  Optimal Sensor Placement for Health Monitoring of High-Rise Structure Based on Genetic Algorithm , 2011 .

[23]  C. Papadimitriou,et al.  The effect of prediction error correlation on optimal sensor placement in structural dynamics , 2012 .

[24]  S. Feng,et al.  Sensor Configuration Optimizing in Modal Identification by Siege ant Colony Algorithm , 2017 .

[25]  Yu Wen-bai An Optimal Sensor Placement Methods Based on the Effective Independence Method , 2011 .

[26]  Lalit M. Patnaik,et al.  Adaptive probabilities of crossover and mutation in genetic algorithms , 1994, IEEE Trans. Syst. Man Cybern..

[27]  Dongsheng Li,et al.  The connection between effective independence and modal kinetic energy methods for sensor placement , 2007 .

[28]  John H. Holland,et al.  Adaptation in Natural and Artificial Systems: An Introductory Analysis with Applications to Biology, Control, and Artificial Intelligence , 1992 .

[29]  Jianchun Xing,et al.  Optimal Sensor Placement for Latticed Shell Structure Based on an Improved Particle Swarm Optimization Algorithm , 2014 .

[30]  Yang Yi,et al.  A partheno-genetic algorithm for multidimensional knapsack problem , 2005, 2005 International Conference on Machine Learning and Cybernetics.

[31]  William A. Sethares,et al.  Sensor placement for on-orbit modal identification via a genetic algorithm , 1993 .

[32]  Peng Li,et al.  Sensor Distribution Optimization for Structural Impact Monitoring Based on NSGA-II and Wavelet Decomposition , 2018, Sensors.