Measurement of microscope calibration standards in nanometrology using a metrological atomic force microscope

Microscope calibration standards in nanometrology were calibrated using a metrological atomic force microscope (metrological AFM) and the validity of calibrated values was shown. The metrological AFM was developed through the modification of a commercial AFM, which replaced the PZT tube scanner with flexure hinge scanners and displacement sensors. These modifications improved the traceability of measured values to metrological primary standards. The grating pitch and step height specimens, which are typical standard artefacts for the calibration of lateral and vertical magnifications of microscopes, were measured using the metrological AFM. The expanded uncertainties (k = 2) of calibrated values were estimated considering the characteristics of the calibration process and were less than 1 nm. The measurement results were compared with those obtained by other metrological methods or the certified values and their consistency was verified by checking the En numbers. These experimental results show that the metrological AFM can be used effectively for the measurements of microscope calibration standards in nanometrology.

[1]  John Alexander,et al.  Design of an atomic force microscope with interferometric position control , 1994 .

[2]  Ichiko Misumi,et al.  Sub-hundred nanometre pitch measurements using an AFM with differential laser interferometers for designing usable lateral scales , 2005 .

[3]  Ikuo Ihara,et al.  Ultrasonic probes for high temperature immersion measurements , 2001 .

[4]  Gaoliang Dai,et al.  Improving the performance of interferometers in metrological scanning probe microscopes , 2004 .

[5]  Kiyoshi Takamasu,et al.  Uncertainty in pitch measurements of one-dimensional grating standards using a nanometrological atomic force microscope , 2003 .

[6]  B. Taylor,et al.  Status Report on the ISO/IEC/OIML/BIPM Guide, Expression of Uncertainty in Measurement , 1992 .

[7]  K. Dirscherl,et al.  Two-dimensional nanometer-scale calibration based on one-dimensional gratings , 1998 .

[8]  Kiyoshi Takamasu,et al.  Submicrometre-pitch intercomparison between optical diffraction, scanning electron microscope and atomic force microscope , 2003 .

[9]  Gaoliang Dai,et al.  Metrological large range scanning probe microscope , 2004 .

[10]  Kiyoshi Takamasu,et al.  Reliability of parameters of associated base straight line in step height samples: Uncertainty evaluation in step height measurements using nanometrological AFM , 2006 .

[11]  J Haycocks,et al.  Traceable calibration of transfer standards for scanning probe microscopy , 2005 .

[12]  S. Standard.  GUIDE TO THE EXPRESSION OF UNCERTAINTY IN MEASUREMENT , 2006 .

[13]  Ludger Koenders,et al.  A combined scanning tunnelling microscope and x-ray interferometer , 2001 .

[14]  Liam Blunt,et al.  Calibration of step heights and roughness measurements with atomic force microscopes , 2003 .

[15]  R. Thalmann,et al.  Long-range AFM profiler used for accurate pitch measurements , 1998 .

[16]  K. Hasche,et al.  A metrological scanning force microscope used for coating thickness and other topographical measurements , 1998 .