An improved thermal and electrical model for a solar photovoltaic thermal (PV/T) air collector

In this paper, an attempt is made to investigate the thermal and electrical performance of a solar photovoltaic thermal (PV/T) air collector. A detailed thermal and electrical model is developed to calculate the thermal and electrical parameters of a typical PV/T air collector. The thermal and electrical parameters of a PV/T air collector include solar cell temperature, back surface temperature, outlet air temperature, open-circuit voltage, short-circuit current, maximum power point voltage, maximum power point current, etc. Some corrections are done on heat loss coefficients in order to improve the thermal model of a PV/T air collector. A better electrical model is used to increase the calculations precision of PV/T air collector electrical parameters. Unlike the conventional electrical models used in the previous literature, the electrical model presented in this paper can estimate the electrical parameters of a PV/T air collector such as open-circuit voltage, short-circuit current, maximum power point voltage, and maximum power point current. Further, an analytical expression for the overall energy efficiency of a PV/T air collector is derived in terms of thermal, electrical, design and climatic parameters. A computer simulation program is developed in order to calculate the thermal and electrical parameters of a PV/T air collector. The results of numerical simulation are in good agreement with the experimental measurements noted in the previous literature. Finally, parametric studies have been carried out. Since some corrections have been down on thermal and electrical models, it is observed that the thermal and electrical simulation results obtained in this paper is more precise than the one given by the previous literature. It is also found that the thermal efficiency, electrical efficiency and overall energy efficiency of PV/T air collector is about 17.18%, 10.01% and 45%, respectively, for a sample climatic, operating and design parameters.

[1]  David Infield,et al.  Thermal performance estimation for ventilated PV facades , 2004 .

[2]  G. N. Tiwari,et al.  Analytical expression for electrical efficiency of PV/T hybrid air collector , 2009 .

[3]  Hossein Ajam,et al.  Thermodynamic optimization of the solar parabolic cookers and comparison with energy analysis , 2008 .

[4]  C. H. Cox,et al.  Design considerations for flat-plate-photovoltaic/thermal collectors , 1985 .

[5]  G. Boyle.  Renewable Energy: Power for a Sustainable Future , 2012 .

[6]  Arvind Tiwari,et al.  Performance evaluation of photovoltaic thermal solar air collector for composite climate of India , 2006 .

[7]  Md. Rafiqul Islam,et al.  Review on solar water heater collector and thermal energy performance of circulating pipe , 2011 .

[8]  Ha Herbert Zondag,et al.  The thermal and electrical yield of a PV-thermal collector , 2002 .

[9]  Morteza Abdolzadeh,et al.  Improving the effectiveness of a photovoltaic water pumping system by spraying water over the front of photovoltaic cells , 2009 .

[10]  Marc A. Rosen,et al.  A critical review of photovoltaic–thermal solar collectors for air heating , 2011 .

[11]  Said Farahat,et al.  Exergetic Performance Evaluation of a Solar Photovoltaic (PV) Array , 2010 .

[12]  Antonio Luque,et al.  Handbook of photovoltaic science and engineering , 2011 .

[13]  Arvind Tiwari,et al.  Energy metrics analysis of hybrid - photovoltaic (PV) modules , 2009 .

[14]  William A. Beckman,et al.  Improvement and validation of a model for photovoltaic array performance , 2006 .

[15]  D. L. Evans,et al.  Simplified method for predicting photovoltaic array output , 1980 .

[16]  J. Coventry.  Performance of a concentrating photovoltaic/thermal solar collector , 2005 .

[17]  Tin-Tai Chow,et al.  A Review on Photovoltaic/Thermal Hybrid Solar Technology , 2010, Renewable Energy.

[18]  M. Wolf,et al.  Performance analyses of combined heating and photovoltaic power systems for residences , 1976 .

[19]  E. C. Kern,et al.  Combined photovoltaic and thermal hybrid collector systems , 1978 .

[20]  David Infield,et al.  Thermal modelling of building integrated PV systems , 2001 .

[21]  Kamaruzzaman Sopian,et al.  Performance of a double pass photovoltaic thermal solar collector suitable for solar drying systems , 2000 .

[22]  Adel A. Hegazy,et al.  Comparative study of the performances of four photovoltaic/thermal solar air collectors. , 2000 .

[23]  Jon Hand,et al.  Building-integrated photovoltaic and thermal applications in a subtropical hotel building , 2003 .

[24]  Tin-Tai Chow,et al.  An experimental study of façade-integrated photovoltaic/water-heating system , 2007 .

[25]  H. Ajam,et al.  Exergetic Optimization of Solar Air Heaters and Comparison with Energy Analysis , 2005 .

[26]  K. F. Fong,et al.  Energy and exergy analysis of photovoltaic-thermal collector with and without glass cover , 2009 .

[27]  Said Farahat,et al.  Exergetic optimization of flat plate solar collectors , 2009 .

[28]  H. P. Garg,et al.  Study of a hybrid solar system—solar air heater combined with solar cells , 1991 .

[29]  Soteris A. Kalogirou,et al.  Use of TRNSYS for modelling and simulation of a hybrid pv–thermal solar system for Cyprus , 2001 .

[30]  Arvind Tiwari,et al.  Exergy analysis of integrated photovoltaic thermal solar water heater under constant flow rate and constant collection temperature modes , 2009 .

[31]  I. Dincer,et al.  Performance evaluation of a hybrid photovoltaic thermal (PV/T) (glass-to-glass) system , 2009 .

[32]  Swapnil Dubey,et al.  Thermal modeling of a combined system of photovoltaic thermal (PV/T) solar water heater , 2008 .

[33]  H. P. Garg,et al.  Experimental study on a hybrid photovoltaic-thermal solar water heater and its performance predictions , 1994 .

[34]  H. P. Garg,et al.  Conventional hybrid photovoltaic/thermal (PV/T) air heating collectors: steady-state simulation , 1997 .