Flow Generated by an Aerated Rushton Impeller: Two‐phase PIV Experiments and Numerical Simulations

A two-camera PIV technique was used to obtain angle resolved velocity and turbulence data of the flow in a lab-scale stirred tank, equipped with a Rushton turbine. Two cases were investigated: a single-phase flow and a gas-liquid flow. In the former case, the classical radial jet flow pattern accompanied by two trailing vortices was observed. In the latter case, the velocity of the radial jet was reduced, and the vortices were diminished by the presence of the gas. Gas cavities clinging to the back of the impeller blades were observed. Both cases were also investigated with the use of three-dimensional transient CFD simulations. For the single-phase flow the simulations in the impeller region correspond very well with the experimental data. For the gas-liquid flow both the mean and fluctuating liquid velocities in the impeller region are well predicted. This is also the case for the mean radial gas velocities.

[1]  João B. P. Soares,et al.  Canadian Journal of Chemical Engineering , 1957, Nature.

[2]  V. Dhir.  BOILING HEAT TRANSFER , 1998 .

[3]  Vivek V. Ranade,et al.  CFD predictions of flow near impeller blades in baffled stirred vessels: Assessment of computational snapshot approach , 2002 .

[4]  Vivek V. Ranade,et al.  Gas–liquid flow in stirred reactors: Trailing vortices and gas accumulation behind impeller blades , 1999 .

[5]  Kendra V. Sharp,et al.  Dissipation Estimation Around a Rushton Turbine Using Particle Image Velocimetry , 2000 .

[6]  Vivek V. Ranade,et al.  An efficient computational model for simulating flow in stirred vessels: a case of Rushton turbine , 1997 .

[7]  Carl M. Stoots,et al.  Mean velocity field relative to a Rushton turbine blade , 1995 .

[8]  J. Westerweel,et al.  Efficient detection of spurious vectors in particle image velocimetry data , 1994 .

[9]  Vivek V. Ranade,et al.  A COMPUTATIONAL SNAPSHOT OF GAS-LIQUID FLOW IN BAFFLED STIRRED REACTORS , 1994 .

[10]  A. Gosman,et al.  PREDICTION OF IMPELLER- INDUCED FLOW IN MIXING VESSELS USING MULTIPLE FRAMES OF REFERENCE , 1994 .

[11]  J. Couderc,et al.  Study by laser Doppler anemometry of the turbulent flow induced by a Rushton turbine in a stirred tank: Influence of the size of the units—I. Mean flow and turbulence , 1988 .

[12]  N. Zuber,et al.  Drag coefficient and relative velocity in bubbly, droplet or particulate flows , 1979 .

[13]  Alvin W. Nienow,et al.  Sliding mesh computational fluid dynamics—a predictive tool in stirred tank design , 1997 .

[14]  Richard D. Keane,et al.  Optimization of particle image velocimeters. I, Double pulsed systems , 1990 .

[15]  Alberto Brucato,et al.  COMPLETE NUMERICAL SIMULATION OF FLOW FIELDS IN BAFFLED STIRRED VESSELS: THE INNER-OUTER APPROACH , 1994 .

[16]  Y. Sato,et al.  Liquid velocity distribution in two-phase bubble flow , 1975 .

[17]  Michael Yianneskis,et al.  Assessment of Sliding Mesh CFD Predictions and LDA Measurements of the Flow in a Tank Stirred by a Rushton Impeller , 1998 .

[18]  Bjørn H. Hjertager,et al.  LDA measurements and CFD modelling of gas-liquid flow in a stirred vessel , 1996 .

[19]  L. Wijngaarden.  Turbulent Two-Phase Flow , 1996 .

[20]  Stein,et al.  Part I: Experimental. , 1998, Journal of colloid and interface science.

[21]  Bjørn H. Hjertager,et al.  Particle image velocimetry measurements in an aerated stirred tank , 1999 .

[22]  L. Fuchs,et al.  Large eddy simulations of the turbulent flow in a stirred reactor , 1998 .

[23]  Hallvard F. Svendsen,et al.  Modeling of Vertical Bubble-Driven Flows , 1997 .

[24]  Suzanne M. Kresta,et al.  Prediction of the three-dimensional turbulent flow in stirred tanks , 1991 .

[25]  Wei-Ming Lu,et al.  Local gas holdup, mean liquid velocity and turbulence in an aerated stirred tank using hot-film anemometry , 1987 .

[26]  Jos Derksen,et al.  Large eddy simulations on the flow driven by a Rushton turbine , 1999 .

[27]  Alberto Brucato,et al.  Numerical prediction of flow fields in baffled stirred vessels: A comparison of alternative modelling approaches , 1998 .

[28]  A. Bakker,et al.  A COMPUTATIONAL MODEL FOR THE GAS-LIQUID FLOW IN STIRRED REACTORS , 1994 .

[29]  Michael Yianneskis,et al.  The Influence of Rushton Impeller Blade and Disk Thickness on the Mixing Characteristics of Stirred Vessels , 1996 .

[30]  Vivek V. Ranade,et al.  Flow generated by a disc turbine. I: Experimental , 1990 .

[31]  Vivek V. Ranade,et al.  Trailing Vortices of Rushton Turbine: PIV Measurements and CFD Simulations with Snapshot Approach , 2001 .

[32]  L. C. Wrobel,et al.  Computational techniques in heat transfer Edited by R. W. Lewis, K. Morgan, J. A. Johnson and W. R. Smith Pineridge Press Ltd, 1985, £25.00/$44.00,ISBN 0-906674-39-5 , 1987 .

[33]  Matthias Reuss,et al.  A critical assessment on the use of k–ε turbulence models for simulation of the turbulent liquid flow induced by a Rushton-turbine in baffled stirred-tank reactors , 1999 .

[34]  Jos Derksen,et al.  Phase-Resolved Three-Dimensional LDA Measurements in the Impeller Region of a Turbulently Stirred Tank , 2000 .

[35]  G. K. Patterson,et al.  Laser-Doppler measurements of turbulent-flow parameters in a stirred mixer , 1989 .

[36]  Donald A. Drew,et al.  ANALYTICAL MODELING OF MULTIPHASE FLOWS , 1992 .

[37]  Gary B. Tatterson,et al.  Fluid mixing and gas dispersion in agitated tanks , 1991 .

[38]  Vivek V. Ranade,et al.  Flow generated by a disc turbine. II: Mathematical modelling and comparison with experimental data , 1990 .

[39]  Ronald Adrian,et al.  Optimization of particle image velocimeters , 1990, Other Conferences.

[40]  F. Durst,et al.  Applications of Laser Techniques to Fluid Mechanics , 1991 .

[41]  Michael Yianneskis,et al.  An experimental study of the steady and unsteady flow characteristics of stirred reactors , 1987, Journal of Fluid Mechanics.