Manufacturing Process Modeling of 100-400 kWe Combined Heat and Power Stationary Fuel Cell Systems

Both technical reviewers are external and Phyllis Daley is serving as proxy. A non-disclosure form is not needed for this report.

[1]  Z. Yang,et al.  Structure and Conductivity of Thermally Grown Scales on Ferritic Fe-Cr-Mn Steel for SOFC Interconnect Applications , 2004 .

[2]  Joyce Smith Cooper,et al.  Taxonomies of SOFC material and manufacturing alternatives , 2005 .

[3]  K. R. Reddy,et al.  Sinterability, Mechanical, Microstructural, and Electrical Properties of Gadolinium-Doped Ceria Electrolyte for Low-Temperature Solid Oxide Fuel Cells , 2005 .

[4]  M. Farooque,et al.  Carbonate fuel cell materials , 2006 .

[5]  D. Stöver,et al.  Processing and Properties of Advanced Solid Oxide Fuel Cells , 2007 .

[6]  Jung-Hoon Song,et al.  Fabrication and Characterization of Anode-Supported Planar Solid Oxide Fuel Cell Manufactured by a Tape Casting Process , 2008 .

[7]  F. Tietz,et al.  Materials and manufacturing technologies for solid oxide fuel cells , 2010 .

[8]  M. Cologna,et al.  Sintering and Deformation of Solid Oxide Fuel Cells Produced by Sequential Tape Casting , 2010 .

[9]  D. Stöver,et al.  MEA/cell preparation methods: Europe/USA , 2010 .

[10]  R. Tomov,et al.  Direct ceramic inkjet printing of yttria-stabilized zirconia electrolyte layers for anode-supported solid oxide fuel cells , 2010 .

[11]  J. Daly,et al.  Effective Sulfur Control for Fuel Cells: FCE Experience , 2010 .

[12]  Z. Jiao,et al.  An ultra-fast fabrication technique for anode support solid oxide fuel cells by microwave , 2011 .

[13]  M. Mori,et al.  Sintering Mechanisms of Cobalt-Doped Ceria and Zirconia Electrolytes in Intermediate-Temperature Solid Oxide Fuel Cells , 2011 .

[14]  Wade A. Rosensteel,et al.  Progress Toward Inkjet Deposition of Segmented-in-Series Solid-Oxide Fuel Cell Architectures , 2011 .