Influence of the Anode Material and the Flushing Gas on the Dry Electrical Discharge Machining Process

[1]  Konrad Wegener,et al.  Influence of Oxidizing Gas on the Stability of Dry Electrical Discharge Machining Process , 2013 .

[2]  Masanori Kunieda,et al.  Electrical Discharge Machining in Gas , 1997 .

[3]  A. Descoeudres.  Characterization of electrical discharge machining plasmas , 2006 .

[4]  Nobuhiro Nakajima,et al.  High Speed 3D Milling by Dry EDM , 2003 .

[5]  D. V. Morgan,et al.  Electron field emission from copper with various thicknesses of oxide film , 1984 .

[6]  Konrad Wegener,et al.  Influence of the Anode Material on the Breakdown Behavior in Dry Electrical Discharge Machining , 2012 .

[7]  M. Kunieda,et al.  Improvement of EDM Efficiency by Supplying Oxygen Gas into Gap , 1991 .

[8]  Štefan Matejčík,et al.  Experimental and theoretical studies of the breakdown voltage characteristics at micrometre separations in air , 2011 .

[9]  Kamlakar P Rajurkar,et al.  Experimental characterization of dry EDM performed in a pulsating magnetic field , 2011 .

[10]  Masanori Kunieda,et al.  Improvement of Dry EDM Characteristics Using Piezoelectric Actuator , 2004 .

[11]  M. Esashi,et al.  Micro-discharge and electric breakdown in a micro-gap , 2000 .

[12]  Norliana Mohd Abbas,et al.  A review on current research trends in electrical discharge machining (EDM) , 2007 .

[13]  Ruxu Du,et al.  An investigation of ultrasonic-assisted electrical discharge machining in gas , 2006 .

[14]  B. Schumacher.  After 60 years of EDM the discharge process remains still disputed , 2004 .

[15]  Katsunori Tamiya,et al.  Electrical Discharge Machining of Cemented Carbide Alloys , 1977 .