论文信息 - Computer simulation of gear tooth manufacturing processes

Computer simulation of gear tooth manufacturing processes

Abstract : This report discusses the use of computer graphics to simulate gear tooth manufacturing procedures. An analytical basis for the simulation is established for spur gears. The simulation itself, however, is developed not only for spur gears, but for straight bevel gears as well. The applications of the developed procedure extend from the development of finite elements models of heretofore intractable geometrical forms, to exploring the fabrication of nonstandard tooth forms. (kr)

Ronald L. Huston | Dimitri Mavriplis

[1] Ronald L. Huston,et al. Finite element methods : an introduction , 1984 .

[2] P C Altidis,et al. Flexibility effects on tooth contact location in spiral bevel gear transmissions , 1987 .

[3] Faydor L. Litvin,et al. Generation of tooth surfaces by two-parameter enveloping , 1975 .

[4] A. Dyson. A general theory of the kinematics and geometry of gears in three dimensions , 1969 .

[5] Joseph Edward Shigley,et al. Mechanical engineering design , 1972 .

[6] Wells Coleman. Design and Manufacture of Spiral Bevel and Hypoid Gears for Heavy-Duty Drive Axles, 1963 , 1963 .

[7] S. Oda,et al. Stress Analysis of Thin Rim Spur Gears by Finite Element Method , 1981 .

[8] J. J. Coy,et al. A finite element stress analysis of spur gears including fillet radii and rim thickness effects , 1983 .

[9] Ronald L. Huston,et al. Tooth Profile Analysis of Circular-Cut, Spiral-Bevel Gears , 1983 .

[10] E. Buckingham. Analytical mechanics of gears , 1949 .