Passive thermal regulation of flat PV modules by coupling the mechanisms of evaporative and fin cooling

A passive thermal regulation technique with fins in conjunction with cotton wicks is developed in the present work for controlling the temperature of PV module during its operation. Experiments were conducted with the developed technique in the location of Tiruchirappalli (78.6°E and 10.8°N), Tamil Nadu, India with flat 25 Wp PV module and its viability was confirmed. The PV module temperature got reduced by 12 % while the electrical yield is increased by 14 % with the help of the developed cooling system. Basic energy balance equation applicable for PV module was used to evaluate the module temperatures and a fair agreement was obtained between the theoretical and experimental values for the cases of with cooling and without cooling.

[1]  Ali Etem Gürel,et al.  Cooling of a photovoltaic module with temperature controlled solar collector , 2014 .

[2]  Masoud Rahimi,et al.  Using a wind-driven ventilator to enhance a photovoltaic cell power generation , 2014 .

[3]  C. Dey,et al.  Cooling of photovoltaic cells under concentrated illumination: a critical review , 2005 .

[4]  Li Zhu,et al.  Heat dissipation performance of silicon solar cells by direct dielectric liquid immersion under intensified illuminations , 2011 .

[5]  Xingxing Zhang,et al.  Review of R&D progress and practical application of the solar photovoltaic/thermal (PV/T) technologies. , 2012 .

[6]  S. C. Solanki,et al.  Photovoltaic modules and their applications: A review on thermal modelling , 2011 .

[7]  Shafiqur Rehman,et al.  Performance evaluation of a PV (photovoltaic) module by back surface water cooling for hot climatic conditions , 2013 .

[8]  Laura Schaefer,et al.  System simulation of a linear concentrating photovoltaic system with an active cooling system , 2012 .

[9]  Y. Çengel.  Heat and Mass Transfer: A Practical Approach , 2006 .

[10]  Gilles Notton,et al.  Calculation of the polycrystalline PV module temperature using a simple method of energy balance , 2006 .

[11]  Tin-Tai Chow,et al.  A Review on Photovoltaic/Thermal Hybrid Solar Technology , 2010, Renewable Energy.

[12]  Nabil Kahoul,et al.  Assessing the early degradation of photovoltaic modules performance in the Saharan region , 2014 .

[13]  Mohammad Nurul Alam Hawlader,et al.  An active cooling system for photovoltaic modules , 2012 .

[14]  Pushpito Kumar Ghosh,et al.  Performance of a silicon photovoltaic module under enhanced illumination and selective filtration of incoming radiation with simultaneous cooling , 2010 .

[15]  R. G. Ross,et al.  Interface design considerations for terrestrial solar cell modules , 1976 .

[16]  Morteza Abdolzadeh,et al.  Improving the effectiveness of a photovoltaic water pumping system by spraying water over the front of photovoltaic cells , 2009 .

[17]  Hongxing Yang,et al.  Thermal regulation of photovoltaic cladding , 1997 .

[18]  A. D. Jones,et al.  A thermal model for photovoltaic systems , 2001 .

[19]  E. Skoplaki,et al.  ON THE TEMPERATURE DEPENDENCE OF PHOTOVOLTAIC MODULE ELECTRICAL PERFORMANCE: A REVIEW OF EFFICIENCY/ POWER CORRELATIONS , 2009 .

[20]  Shenyi Wu,et al.  Passive cooling technology for photovoltaic panels for domestic houses , 2014 .

[21]  M. J. Huang,et al.  The effect of using two PCMs on the thermal regulation performance of BIPV systems , 2009 .

[22]  Mats Sandberg,et al.  Design procedure for cooling ducts to minimise efficiency loss due to temperature rise in PV arrays , 2006 .

[23]  S. Krauter.  Increased electrical yield via water flow over the front of photovoltaic panels , 2004 .

[24]  P. Chidambaram,et al.  Study of Thermal Comfort Properties of Cotton/Regenerated Bamboo Knitted Fabrics , 2012 .

[25]  Li Zhu,et al.  The performance of silicon solar cells operated in liquids , 2009 .

[26]  Brian Norton,et al.  Phase change materials for limiting temperature rise in building integrated photovoltaics , 2006 .

[27]  B. J. Brinkworth,et al.  Optimum depth for PV cooling ducts , 2006 .

[28]  Abdessamad Kobi,et al.  Degradation evaluation of crystalline-silicon photovoltaic modules after a few operation years in a tropical environment , 2014 .

[29]  Chetan Singh Solanki,et al.  Enhanced heat dissipation of V-trough PV modules for better performance , 2008 .

[30]  Abdul Hai Alami,et al.  Effects of evaporative cooling on efficiency of photovoltaic modules , 2014 .

[31]  Masud Behnia,et al.  Improving Photovoltaic Module Efficiency Using Water Cooling , 2009 .

[32]  Christopher Dey,et al.  Design of a jet impingement cooling device for densely packed PV cells under high concentration , 2007 .

[33]  E. Radziemska,et al.  Thermally affected parameters of the current–voltage characteristics of silicon photocell , 2002 .

[34]  Pushpito Kumar Ghosh,et al.  Self regulation of photovoltaic module temperature in V-trough using a metal–wax composite phase change matrix , 2011 .

[35]  Mohan Kolhe,et al.  Performance analysis of water cooled concentrated photovoltaic (CPV) system , 2012 .

[36]  Zifeng Yuan,et al.  Simulation and experimental validation of heat transfer in a novel hybrid solar panel , 2012 .

[37]  Paolo Rosa-Clot,et al.  Optical and thermal behavior of submerged photovoltaic solar panel: SP2 , 2012 .

[38]  B. Sandnes,et al.  A photovoltaic/thermal (PV/T) collector with a polymer absorber plate. Experimental study and analytical model , 2002 .

[39]  T. Senthilkumar,et al.  Passive cooling of standalone flat PV module with cotton wick structures , 2013 .