Corrosion behavior, biocompatibility and biomechanical stability of a prototype magnesium-based biodegradable intramedullary nailing system.

Implants made of degradable magnesium alloys are a potential alternative to conventional orthopaedic implant materials, e.g. stainless steel or titanium. Intramedullary nails made of the magnesium alloy LAE442 were subjected to cyclic fatigue tests in both distilled water and Hank's Balanced Salt Solution (HBSS) at 37.5°C until implant failure or a limit of 500,000cycles was reached. In distilled water, four of the five nails were still intact after the end of the biomechanical test. In HBSS, a breakage within the first 70,000 bending cycles was observed. Additionally, the degradation rate of this alloy was determined in HBSS according to the weight loss method (0.24±0.12mmyear(-1)) and based on gas release (0.21±0.03mmyear(-1)) with a standard eudiometer. A cytotoxicity test with L929 cells was carried out in accordance with EN ISO 10993-5/12. This test demonstrated sufficient cell viability of the diluted extracts (50%, 25% and 12.5%). The relative metabolic activity of the 100% extract was reduced slightly below 70%, which is classified as a threshold value for cytotoxicity. In conclusion, this in vitro study indicates that intramedullary nails made of LAE442 may not have the required fatigue resistance for load-bearing applications and the development of a corrosion-protective coating may be necessary to prevent early failure of the implant.

[1]  P. O. Ganrot Metabolism and possible health effects of aluminum. , 1986, Environmental health perspectives.

[2]  Bastian Welke,et al.  In vivo evaluation of a magnesium-based degradable intramedullary nailing system in a sheep model. , 2015, Acta biomaterialia.

[3]  J. Nellesen,et al.  In vitro and in vivo evaluation of biodegradable, open-porous scaffolds made of sintered magnesium W4 short fibres. , 2013, Acta biomaterialia.

[4]  Yufeng Zheng,et al.  In vitro degradation performance and biological response of a Mg-Zn-Zr alloy , 2011 .

[5]  Darren J. Martin,et al.  Corrosion of high purity Mg, Mg2Zn0.2Mn, ZE41 and AZ91 in Hank’s solution at 37 °C , 2011 .

[6]  Andrea Meyer-Lindenberg,et al.  Comparison of morphological changes in efferent lymph nodes after implantation of resorbable and non-resorbable implants in rabbits , 2011, Biomedical engineering online.

[7]  Alexis M Pietak,et al.  Magnesium and its alloys as orthopedic biomaterials: a review. , 2006, Biomaterials.

[8]  E. Gutman,et al.  Corrosion fatigue of extruded magnesium alloys , 2003 .

[9]  E. Zhang,et al.  Biocorrosion behavior of magnesium alloy in different simulated fluids for biomedical application , 2009 .

[10]  Andrej Atrens,et al.  Measurement of the corrosion rate of magnesium alloys using Tafel extrapolation , 2010 .

[11]  Carolin Hampp,et al.  Evaluation of the biocompatibility of two magnesium alloys as degradable implant materials in comparison to titanium as non-resorbable material in the rabbit. , 2013, Materials science & engineering. C, Materials for biological applications.

[12]  Janine Fischer,et al.  Improved cytotoxicity testing of magnesium materials , 2011 .

[13]  Y. Uematsu,et al.  Corrosion fatigue behavior of extruded AZ80, AZ61, and AM60 magnesium alloys in distilled water , 2008 .

[14]  Tim Woodfield,et al.  Magnesium alloys: predicting in vivo corrosion with in vitro immersion testing. , 2012, Journal of biomedical materials research. Part B, Applied biomaterials.

[15]  Y. Mutoh,et al.  Corrosion fatigue behavior of extruded magnesium alloy AZ80-T5 in a 5% NaCl environment , 2010 .

[16]  Andrej Atrens,et al.  A Critical Review of the Stress Corrosion Cracking (SCC) of Magnesium Alloys , 2005 .

[17]  W. Mueller,et al.  Critical discussion of the results from different corrosion studies of Mg and Mg alloys for biomaterial applications. , 2010, Acta biomaterialia.

[18]  Jochem Nagels,et al.  Stress shielding and bone resorption in shoulder arthroplasty. , 2003, Journal of shoulder and elbow surgery.

[19]  Karl Ulrich Kainer,et al.  Element distribution in the corrosion layer and cytotoxicity of alloy Mg-10Dy during in vitro biodegradation. , 2013, Acta biomaterialia.

[20]  S. Hirano,et al.  Exposure, metabolism, and toxicity of rare earths and related compounds. , 1996, Environmental health perspectives.

[21]  M. Leeflang,et al.  In vitro degradation behavior and cytocompatibility of Mg–Zn–Zr alloys , 2010, Journal of materials science. Materials in medicine.

[22]  G. Thouas,et al.  Metallic implant biomaterials , 2015 .

[23]  H. Haferkamp,et al.  In vivo corrosion of four magnesium alloys and the associated bone response. , 2005, Biomaterials.

[24]  Frank Witte,et al.  In vitro and in vivo corrosion measurements of magnesium alloys. , 2006, Biomaterials.

[25]  D. Mantovani,et al.  Design of a pseudo-physiological test bench specific to the development of biodegradable metallic biomaterials. , 2008, Acta biomaterialia.

[26]  Vilmos Vécsei,et al.  Intramedullary nailing in fracture treatment: history, science and Küntscher's revolutionary influence in Vienna, Austria. , 2011, Injury.

[27]  Y. Zheng,et al.  Corrosion fatigue behaviors of two biomedical Mg alloys - AZ91D and WE43 - In simulated body fluid. , 2010, Acta biomaterialia.

[28]  Janine Fischer,et al.  Chemical surface alteration of biodegradable magnesium exposed to corrosion media. , 2011, Acta biomaterialia.

[29]  Yufeng Zheng,et al.  In vitro corrosion and biocompatibility of binary magnesium alloys. , 2009, Biomaterials.

[30]  Berend Denkena,et al.  Biodegradable magnesium implants for orthopedic applications , 2012, Journal of Materials Science.

[31]  Yufeng Zheng,et al.  Corrosion resistance and surface biocompatibility of a microarc oxidation coating on a Mg-Ca alloy. , 2011, Acta biomaterialia.

[32]  Vladimir Zaichick,et al.  Accumulation of rare earth elements in human bone within the lifespan. , 2011, Metallomics : integrated biometal science.

[33]  C. Ceccarini,et al.  pH as a determinant of cellular growth and contact inhibition. , 1971, Proceedings of the National Academy of Sciences of the United States of America.

[34]  T. Haley,et al.  Pharmacology and toxicology of the rare earth elements. , 1965, Journal of pharmaceutical sciences.

[35]  E. Gutman,et al.  Corrosion fatigue of die-cast and extruded magnesium alloys , 2001 .

[36]  F. Beckmann,et al.  In vivo corrosion and corrosion protection of magnesium alloy LAE442. , 2010, Acta biomaterialia.

[37]  G. Song,et al.  Corrosion mechanisms of magnesium alloys , 1999 .

[38]  Y. Mutoh,et al.  Corrosion fatigue behavior of extruded magnesium alloy AZ61 under three different corrosive environments , 2008 .

[39]  R. Gilles,et al.  Effect of high osmolarity acclimation on tolerance to hyperosmotic shocks in L929 cultured cells. , 1995, Tissue & cell.

[40]  E Schneider,et al.  Loads acting in an intramedullary nail during fracture healing in the human femur. , 2001, Journal of biomechanics.

[41]  Henning Windhagen,et al.  Comparative in vitro study and biomechanical testing of two different magnesium alloys , 2014, Journal of biomaterials applications.

[42]  C. Davies,et al.  Corrosion fatigue of a magnesium alloy in modified simulated body fluid , 2015 .

[43]  Henning Windhagen,et al.  Novel magnesium alloy Mg-2La caused no cytotoxic effects on cells in physiological conditions. , 2014, Materials science & engineering. C, Materials for biological applications.