Full range analog Wheatstone bridge‐based automatic circuit for differential capacitance sensor evaluation

Summary In this paper, an integrable novel fully analog Wheatstone bridge-based interface for differential capacitance estimation is presented. Its working principle takes advantage of the modified De-Sauty AC bridge configuration being employed only by two capacitors and two resistors. A feedback loop controls one of the resistors (e.g. a voltage-controlled resistor), to obtain an evaluation of the differential capacitance variation on a full range, thanks to a general but very simple formula that considers both the ‘auto-balancing’ and the bridge ‘out-of-equilibrium’ ranges. The proposed interface shows a satisfactory accuracy, being the percentage relative error within 0.45% for the experimental results. Copyright © 2016 John Wiley & Sons, Ltd.

[1]  Josep Jordana,et al.  A simple, efficient interface circuit for piezoresistive pressure sensors , 2006 .

[2]  Vittorio Ferrari,et al.  ASIC front-end interface with frequency and duty cycle output for resistive-bridge sensors , 2007 .

[3]  Yusuf Leblebici,et al.  A subthreshold current‐sensing ΣΔ modulator for low‐voltage and low‐power sensor interfaces , 2015, Int. J. Circuit Theory Appl..

[4]  Kenzo Watanabe,et al.  A high-accuracy high-speed signal processing circuit of differential-capacitance transducers , 1998, IEEE Trans. Instrum. Meas..

[5]  V. Jagadeesh Kumar,et al.  Digital Converter for Differential Capacitive Sensors , 2006, IEEE Transactions on Instrumentation and Measurement.

[6]  Boby George,et al.  Switched Capacitor Signal Conditioning for Differential Capacitive Sensors , 2007, IEEE Transactions on Instrumentation and Measurement.

[7]  Giuseppe Ferri,et al.  Analog Wheatstone bridge-based automatic interface for grounded and floating wide-range resistive sensors , 2013 .

[8]  Anjan Rakshit,et al.  Development and study of an automatic AC bridge for impedance measurement , 2001, IEEE Trans. Instrum. Meas..

[9]  Gerard C. M. Meijer,et al.  A simple accurate bridge-transducer interface with continuous autocalibration , 1997 .

[10]  C. Di Natale,et al.  A contribution on some basic definitions of sensors properties , 2001, IEEE Sensors Journal.

[11]  Giuseppe Ferri,et al.  Uncalibrated automatic bridge-based CMOS integrated interfaces for wide-range resistive sensors portable applications , 2014, Microelectron. J..

[12]  Giuseppe Ferri,et al.  A novel 6-decades fully-analog uncalibrated Wheatstone bridge-based resistive sensor interface , 2013 .

[13]  Kari Halonen,et al.  High-resolution continuous-time interface for micromachined capacitive accelerometer , 2009 .

[14]  Tarikul Islam,et al.  A time domain bridge-based impedance measurement technique for wide-range lossy capacitive sensors , 2015 .

[15]  Gerard C. M. Meijer,et al.  A high-temperature electronic system for pressure-transducers , 2000, IEEE Trans. Instrum. Meas..

[16]  M. Santonico,et al.  Detection and identification of cancers by the electronic nose. , 2012, Expert opinion on medical diagnostics.

[17]  Alessandro Trifiletti,et al.  88-$\mu$ A 1-MHz Stray-Insensitive CMOS Current-Mode Interface IC for Differential Capacitive Sensors , 2014, IEEE Transactions on Circuits and Systems I: Regular Papers.

[18]  G. Ferri,et al.  Analog current-mode interfaces for differential capacitance sensing , 2016, 2016 IEEE Sensors Applications Symposium (SAS).

[19]  Giuseppe Ferri,et al.  Novel Modified De-Sauty Autobalancing Bridge-Based Analog Interfaces for Wide-Range Capacitive Sensor Applications , 2014, IEEE Sensors Journal.

[20]  Jichun Zhang,et al.  A Universal Micro-Sensor Interface chip with network communication bus and highly programmable sensor readout , 2002, The 2002 45th Midwest Symposium on Circuits and Systems, 2002. MWSCAS-2002..