A general framework for cobot control

A general framework is presented for the design and analysis of cobot controllers. Cobots are inherently passive robots intended for direct collaborative work with a human operator. While a human applies forces and moments, the controller guides motion by tuning the cobot's set of continuously variable transmissions. In this paper, a path following controller is developed that steers the cobot so as to asymptotically approach and follow a pre-planned path. The controller is based on feedback linearization. Generality across cobot architectures is assured by designing the controller in task space and developing transformations between each of four spaces: task space, joint space, a set of coupling spaces, and steering space.

[1]  A. Isidori.  Nonlinear Control Systems: An Introduction , 1986 .

[2]  Claude Samson,et al.  Feedback control of a nonholonomic wheeled cart in Cartesian space , 1991, Proceedings. 1991 IEEE International Conference on Robotics and Automation.

[3]  Weiping Li,et al.  Applied Nonlinear Control , 1991 .

[4]  Louis B. Rosenberg.  “Virtual fixtures”: perceptual overlays enhance operator performance in telepresence tasks , 1994 .

[5]  Woojin Chung,et al.  Design of a nonholonomic manipulator , 1994, Proceedings of the 1994 IEEE International Conference on Robotics and Automation.

[6]  Richard P. Paul,et al.  An Operator Interface for Teleprogramming Employing Synthetic Fixtures , 1994, Presence: Teleoperators & Virtual Environments.

[7]  J. E. Colgate,et al.  Cobots: Robots for Collaboration With Human Operators , 1996, Dynamic Systems and Control.

[8]  J. Edward Colgate,et al.  Cobot control , 1997, Proceedings of International Conference on Robotics and Automation.

[9]  J. Edward Colgate,et al.  Design of a 3R cobot using continuous variable transmissions , 1999, Proceedings 1999 IEEE International Conference on Robotics and Automation (Cat. No.99CH36288C).

[10]  J. Edward Colgate,et al.  Cobot architecture , 2001, IEEE Trans. Robotics Autom..