Micromilling of thin ribs with high aspect ratios

Micro features with high aspect ratios are one of the commonly encountered geometries found in micro products. In the literature, these structures are often used in demonstrator products machined by a micromilling process. In this paper, the challenges in micromilling thin ribs ith high aspect ratios have been studied. Due to the scaling effect, micro-ribs have relatively low stiffness but high natural frequency. Therefore, on the one hand, average forces have to be controlled well to avoid structural bending or even damage, while on the other hand, micro features are unlikely to be excited by the dynamic forces. The characteristics of micromilling forces and their relationships to the machining parameters, namely, feed per tooth, depth of cut and width of cut, were studied theoretically by force models. In addition, the effects of different milling strategies (up-/down-milling) and tool paths on the quality of thin features have been investigated using FEM. The results allow measures to be taken to minimize the force effects and support the micro features during machining. The experimental results verify the theoretical studies. Thin ribs about 15 ?m wide and with an aspect ratio of more than 50 were machined with good form and surface quality.

[1]  D. Choi,et al.  A Study of the Micro Pole Structure Fabrication and Application Technology by Micro End-Milling Process , 2004 .

[2]  Chang Ju Kim,et al.  A static model of chip formation in microscale milling , 2004 .

[3]  Takahisa Masuzawa,et al.  State of the Art of Micromachining , 2000 .

[4]  Eckart Uhlmann,et al.  Dynamic Load and Strain Analysis for the Optimization of Micro End Mills , 2005 .

[5]  Kornel Ehmann,et al.  The Mechanics of Machining at the Microscale: Assessment of the Current State of the Science , 2004 .

[6]  Duc Truong Pham,et al.  Micro milling of thin features , 2005 .

[7]  A. Kumar,et al.  Micro milling of pure copper , 2001 .

[8]  István Mészáros,et al.  Micromilling of metallic materials , 2003 .

[9]  Young-bong Bang,et al.  5-axis micro milling machine for machining micro parts , 2005 .

[10]  Richard E. DeVor,et al.  On the Modeling and Analysis of Machining Performance in Micro-Endmilling, Part I: Surface Generation , 2004 .

[11]  P. T. Tang,et al.  Comparison between microfabrication technologies for metal tooling , 2006 .

[12]  Y. Takeuchi,et al.  Creation of Ultra-precision Microstructures with High Aspect Ratios , 2006 .

[13]  Hiroaki Tanaka,et al.  Minimum thickness of cut in micromachining , 1992 .

[14]  Atanas Ivanov,et al.  Micromilling strategies for machining thin features , 2006 .

[15]  Jon Rigelsford,et al.  Manufacturing Automation: Metal Cutting Mechanics, Machine Tool Vibrations, and CNC Design , 2004 .