Abstract A two-phase gas—liquid flow was studied in small diameter (1.6 mm i.d.) horizontal tubes. Adiabatic flow of air-water mixtures was tested over a range of flow rates, 1000:1 for air and 600:1 for water. Flow maps were established for four systems with different contact angles. Each system contained the same fluids (air and water) and had the same tube diameter, however, the tube material was different for each system. The four tube materials were pyrex, polyethylene, polyurethane and FEP, a fluoropolymer resin. Three of the contact angles, measured on a flat sample of each tube material, were partially wetting (34° 61° and 74°) and one was partially non-wetting (106°). The flow maps for the systems were very similar except for a region of rivulet flow. Rivulet flow is a new flow regime that replaces wavy flow when the contact angle becomes large. On the other hand, the transition boundaries for the non-wetting system, except for the plug—slug transition, were significantly changed.
[1]
J. Weisman,et al.
Effects of fluid properties and pipe diameter on two-phase flow patterns in horizontal lines
,
1979
.
[2]
Thomas J. Hanratty,et al.
Detection of slug flow from pressure measurements
,
1987
.
[3]
A. E. Dukler,et al.
Gas-liquid flow at microgravity conditions—I. Dispersed bubble and slug flow
,
1991
.
[4]
M. W. Wambsganss,et al.
Two-phase flow patterns and transitions in a small, horizontal, rectangular channel
,
1991
.
[5]
Charles A. Rader,et al.
Resistance to Flow in Capillary Systems of Positive Contact Angle
,
1964
.
[6]
A. Dukler,et al.
A model for predicting flow regime transitions in horizontal and near horizontal gas‐liquid flow
,
1976
.
[7]
Mikio Suo,et al.
Two phase flow in capillary tubes
,
1964
.
[8]
K. Aziz,et al.
A flow pattern map for gas—liquid flow in horizontal pipes
,
1974
.