Accounting for anisotropic effects in the prediction of the hydro-mechanical response of a ventilated tunnel in an argillaceous rock

In order to investigate the hydro-mechanical (HM) and chemical perturbations induced in an argillaceous formation by forced ventilation during the operational period of a nuclear waste repository, a specific experiment has been performed in a tunnel, at Mont Terri Underground Research Laboratory (URL) in Switzerland. This experiment has been selected in the international project DECOVALEX for model validation and the numerical simulation of this ventilation experiment (VE) is the object of the present paper. Since the argillaceous rock exhibits anisotropic properties, particular attention is given to the evaluation of the effects of various anisotropic features on the predicted results. In situ measurements such as relative humidity (RH), global water mass extracted, pore water pressure, water content, and relative displacements are compared to predictions using both isotropic and anisotropic parameters. Water permeability anisotropy is shown to be the most influencing parameter by far, whereas in situ stress anisotropy has an effect only during the excavation phase. The anisotropy for mechanical parameterization has also some influence, in particular through HM couplings. These HM couplings have the potential to be very significant in terms of providing confidence in describing the experimental observation, and should be considered for further investigation.

[1]  G. W. Lanyon,et al.  Measurement of in-situ stress in weak rocks at Mont Terri Rock Laboratory, Switzerland , 2003 .

[2]  B. Schrefler,et al.  The Finite Element Method in the Static and Dynamic Deformation and Consolidation of Porous Media , 1998 .

[3]  W. Flügge.  Handbook of Engineering Mechanics , 1962 .

[4]  S. Siegesmund,et al.  Influence of carbonate microfabrics on the failure strength of claystones , 2009 .

[5]  Y. Ohnishi,et al.  Development of finite element code for the analysis of coupled Thermo-Hydro-Mechanical behaviors of a saturated-unsaturated medium , 1987 .

[6]  A. Millard,et al.  Identification of the Hydro‐Mechanical In‐Situ Properties of Tournemire Argillite from Mine‐by‐Test Experiment , 2013 .

[7]  L. R. Van Loon,et al.  Preferred orientations and anisotropy in shales: Callovo-Oxfordian shale (France) and Opalinus Clay (Switzerland) , 2008 .

[8]  In situ determination of anisotropic permeability of clay , 2011 .

[9]  Alain Millard,et al.  Approaches for representing hydro-mechanical coupling between sub-surface excavations and argillaceous porous media at the ventilation experiment, Mont Terri , 2013 .

[10]  Paul Bossart,et al.  Structural and hydrogeological characterisation of the excavation-disturbed zone in the Opalinus Clay (Mont Terri Project, Switzerland) , 2004 .

[12]  L. A. Richards.  Capillary conduction of liquids through porous mediums , 1931 .

[13]  Alain Millard,et al.  A Modern Approach of Large Computer Codes for Structural Analysis , 1989 .

[14]  Van Genuchten,et al.  A closed-form equation for predicting the hydraulic conductivity of unsaturated soils , 1980 .

[15]  C. Martin,et al.  The mechanical behaviour of weak mudstone (Opalinus Clay) at low stresses , 2007 .

[16]  J. Bear,et al.  Introduction to Modeling of Transport Phenomena in Porous Media , 1990 .

[17]  Antonio Gens,et al.  Analysis of hydro-mechanical processes in a ventilated tunnel in an argillaceous rock on the basis of different modelling approaches , 2013 .

[18]  Antonio Gens,et al.  Modelling benchmark of a laboratory drying test in opalinus clay , 2010 .