论文信息 - MRR and TWR evaluation on electrical discharge machining of Ti-6Al-4V using tungsten : copper composite electrode - 字舞流文

MRR and TWR evaluation on electrical discharge machining of Ti-6Al-4V using tungsten : copper composite electrode

J Prasanna | S Rajamanickam | O Amith Kumar | G Karthick Raj | P V V Sathya Narayanan | P. Narayanan | S. Rajamanickam | J. Prasanna | O. Kumar | G. Karthick Raj

[1] C. Wykes,et al. A new method of optimising material removal rate using EDM with copper–tungsten electrodes , 2000 .

[2] Y. Wong,et al. Effect of TiC in copper–tungsten electrodes on EDM performance , 2001 .

[3] Che Hassan Che Haron,et al. Investigation on the influence of machining parameters when machining tool steel using EDM , 2001 .

[4] M. L. Jeswani. Small hole drilling in EDM , 1979 .

[5] P. M. George,et al. EDM machining of carbon–carbon composite—a Taguchi approach , 2004 .

[6] Sachin Maheshwari,et al. Some investigations into the electric discharge machining of hardened tool steel using different electrode materials , 2004 .

[7] R. Jeyapaul,et al. Application of Grey Entropy and Regression Analysis for Modelling and Prediction on Tool Materials Performance During EDM of Hot Pressed ZrB2 at Different Duty Cycles , 2012 .