Estimating relative deposition rates in a multi-source continuous-deposition process using a single composition sensor

When only a single composition sensor is available for a multi-zone co-evaporation process, it can be difficult to determine the relative amount of material deposited in each zone. In this paper, a method of estimating the deposition-rate ratio between zones using small signal perturbation sequences is presented that exploits the exponential dependence of deposition rate on the temperature of the molten metal. A quality metric for the ratio estimate is presented, which can be easily calculated. Then, in order to determine the best perturbation sequence that meets all manufacturing constraints, a constrained optimization problem is described that is shown to be convex. An interesting feature of the solution is the importance of correlations between purturbation inputs. Experimental and simulation results are presented to validate the method.

[1]  P. Strevens.  Iii , 1985 .

[2]  M. Melamed.  Detection , 2021, SETI: Astronomy as a Contact Sport.

[3]  B. Utz,et al.  Continuous YBa/sub 2/Cu/sub 3/O/sub 7-/spl delta// film deposition by optically controlled reactive thermal co-evaporation , 1997, IEEE Transactions on Applied Superconductivity.

[4]  A. Gualtierotti.  H. L. Van Trees, Detection, Estimation, and Modulation Theory, , 1976 .

[5]  Lennart Ljung,et al.  System Identification: Theory for the User , 1987 .

[6]  Raman K. Mehra,et al.  Optimal input signals for parameter estimation in dynamic systems--Survey and new results , 1974 .

[7]  Donald M. Wiberg,et al.  Dynamic system identification: Experiment design and data analysis , 1983 .

[8]  E. Yaz.  Linear Matrix Inequalities In System And Control Theory , 1998, Proceedings of the IEEE.

[9]  T. Vincent,et al.  In situ X-ray fluorescence used for real-time control of CuInxGa1−xSe2 thin film composition , 2002 .

[10]  C. J. Smithells,et al.  Smithells metals reference book , 1949 .

[11]  D. W. Hoffman,et al.  Thin-Film Deposition: Principles and Practice , 1996 .

[12]  D.G. Dudley,et al.  Dynamic system identification experiment design and data analysis , 1979, Proceedings of the IEEE.

[13]  M.J. Hilt,et al.  Estimating relative deposition in a multi-zone process using a single composition sensor , 2005, Proceedings of the 2005, American Control Conference, 2005..

[14]  Robert W. Birkmire,et al.  POLYCRYSTALLINE THIN FILM SOLAR CELLS:Present Status and Future Potential , 1997 .

[15]  Francis J. Doyle,et al.  Manufacture of Thin-Film Solar Cells: Modeling and Control of Cu(InGa)Se2 Physical Vapor Deposition onto a Moving Substrate , 2004 .