Angle diversity and rate-adaptive transmission for indoor wireless optical communications

The main degrading factor in indoor wireless optical communication systems for bit rates up to several megabits per second is the shot noise induced by ambient light (sunlight and artificial light produced by incandescent and fluorescent lamps). Due to the directional nature of both signal and ambient light noise, the spatial distribution of the signal-to-noise ratio in indoor environments can show large variations. This article compares techniques that are able to mitigate the effect of such SNR variations: rate-adaptive transmission and angle diversity. In the first technique, the effective data rate is adjusted to the local SNR conditions by introducing different levels of redundancy. The second technique explicitly explores the directionality of the SNR by combining signals collected from different observation angles. We address the performance of rate-adaptive transmission and angle diversity techniques, and compare them based on experimental results obtained in a typical indoor environment.

[1]  Antonio M. Tavares,et al.  Performance of wireless infrared transmission systems considering both ambient light interference and intersymbol interference due to multipath dispersion , 1999, Other Conferences.

[2]  Joseph M. Kahn,et al.  Imaging diversity receivers for high-speed infrared wireless communication , 1998, IEEE Commun. Mag..

[3]  Joseph M. Kahn,et al.  Wireless Infrared Communications , 1994 .

[4]  Walter Hirt,et al.  Dynamic Cell Planning for Wireless Infrared In-House Data Transmission , 1994, Mobile Communications.

[5]  Rui Valadas,et al.  Angle Diversity to Combat the Ambient Noise in Indoor Optical Wireless Communication Systems , 1997, Int. J. Wirel. Inf. Networks.

[6]  Joseph M. Kahn,et al.  Rate-adaptive modulation techniques for infrared wireless communications , 1999, 1999 IEEE International Conference on Communications (Cat. No. 99CH36311).

[7]  Joseph M. Kahn,et al.  Angle diversity for nondirected wireless infrared communication , 2000, IEEE Trans. Commun..

[8]  U. Bapst,et al.  Wireless in-house data communication via diffuse infrared radiation , 1979 .

[9]  Rui Valadas,et al.  The infrared physical layer of the IEEE 802.11 standard for wireless local area networks , 1998 .

[10]  A. Gameiro,et al.  Coding of PPM based modulation techniques to improve the performance of infrared WLANs , 2000, Vehicular Technology Conference Fall 2000. IEEE VTS Fall VTC2000. 52nd Vehicular Technology Conference (Cat. No.00CH37152).

[11]  Stuart Williams.  IrDA: past, present and future , 2000, IEEE Wirel. Commun..