Estimation of Passenger Car Equivalents for single-lane roundabouts using a microsimulation-based procedure

Calibration of microscopic traffic simulation models for single-lane roundabouts.Use of a meta-analytical estimation of critical and follow up headways.Use of a genetic algorithm-based procedure.Calculation of passenger car equivalents for single-lane roundabouts. Passenger car equivalents for heavy vehicles are required to carry out capacity calculations and perform operational analysis of any road entity (roadway segments or intersections). At single-lane roundabouts, the constraints to the vehicular trajectories imposed by the curvilinear geometric design and the driver's gap acceptance behaviour are expected to produce an impact of the heavy vehicles on the quality of traffic flow different from that produced on freeways and two-lane highways or other at-grade intersections. This is also because entering flow is opposed by the circulating flow which has priority and travels in an anticlockwise direction on a single-lane path around the central island.This paper addresses the question of how to estimate the passenger car equivalents for heavy vehicles on single-lane roundabouts. First, a comparison was performed between the empirical capacity functions based on a meta-analytic estimation of the critical and the follow up headways and the simulation outputs manually obtained for a single-lane roundabout built in Aimsun microscopic simulator. A genetic algorithm-based calibration procedure, therefore, was used to reach a better convergence between the simulation outputs and the empirical capacities. Based on the calibrated model, the passenger car equivalents were determined by comparing the capacity functions built for a fleet of passenger cars with the capacity functions calculated for different percentages of heavy vehicles. Differently from HCM 2010 which assumes a heavy vehicle to be equivalent to two passenger cars and sets as 2.0 the passenger car equivalents for heavy vehicles for roundabouts, a higher PCE effect would be expected on the quality of traffic conditions when the traffic stream contains a high number of heavy vehicles; this effect should be accounted for when calculating capacity and level-of-services.

[1]  L. Darrell Whitley,et al.  Serial and Parallel Genetic Algorithms as Function Optimizers , 1993, ICGA.

[2]  W D Cunagin,et al.  PASSENGER CAR EQUIVALENTS FOR RURAL HIGHWAYS , 1982 .

[3]  William R McShane,et al.  EFFECT OF TRUCKS, BUSES, AND RECREATIONAL VEHICLES ON FREEWAY CAPACITY AND SERVICE VOLUME , 1979 .

[4]  Venkatachalam Thamizh Arasan,et al.  INFLUENCE OF TRAFFIC MIX ON PCU VALUE OF VEHICLES UNDER HETEROGENEOUS TRAFFIC CONDITIONS , 2013 .

[5]  W D Glauz,et al.  SPEEDS AND SERVICE ON MULTILANE UPGRADES , 1976 .

[6]  R T Luttinen.  Properties of Cowan’s M3 Headway Distribution , 1999 .

[7]  José Reynaldo Setti,et al.  Limitations of Passenger-Car Equivalent Derivation for Traffic Streams with More Than One Truck Type , 2003 .

[8]  Thomas Bäck,et al.  Evolutionary Algorithms in Theory and Practice , 1996 .

[9]  Tom V. Mathew,et al.  Calibration of Microsimulation Models for Nonlane-Based Heterogeneous Traffic at Signalized Intersections , 2010 .

[10]  William R. McShane,et al.  A review of pedestrian safety models for urban areas in Low and Middle Income Countries , 2016 .

[11]  O. Giuffrè,et al.  Estimating the Safety Performance Function for Urban Unsignalized Four-Legged One-Way Intersections in Palermo, Italy , 2014 .

[12]  Nostrand Reinhold,et al.  the utility of using the genetic algorithm approach on the problem of Davis, L. (1991), Handbook of Genetic Algorithms. Van Nostrand Reinhold, New York. , 1991 .

[13]  Weng Tat Chan,et al.  ROAD-MAINTENANCE PLANNING USING GENETIC ALGORITHMS.. , 1994 .

[14]  Ahmed Al-Kaisy,et al.  Developing passenger car equivalents for heavy vehicles on freeways during queue discharge flow , 2002 .

[15]  George F. List,et al.  Roundabouts in the United States , 2007 .

[16]  Yaduvir Singh,et al.  Genetic Algorithms: Concepts, Design for Optimization of Process Controllers , 2011, Comput. Inf. Sci..

[17]  Lily Elefteriadou,et al.  Development of Passenger Car Equivalents for Freeways, Two-Lane Highways, and Arterials , 1997 .

[18]  Raffaele Mauro,et al.  Calculation of Roundabouts: Capacity, Waiting Phenomena and Reliability , 2010 .

[19]  Guan Zhi-chao.  Analyze Research on Signal Control Based on Vehicular Emission of Urban Road Roundabout , 2008 .

[20]  Shriniwas S Arkatkar,et al.  Microsimulation Study of Effect of Volume and Road Width on PCU of Vehicles under Heterogeneous Traffic , 2010 .

[21]  Orazio Giuffrè,et al.  Gap-accepteance parameters for roundabouts: a systematic review , 2015 .

[22]  Umama Ahmed,et al.  Passenger Car Equivalent Factors for Level Freeway Segments Operating under Moderate and Congested Conditions , 2010 .

[23]  Roy Sumner,et al.  Segment passenger car equivalent values for cost allocation on urban arterial roads , 1984 .

[24]  Rahmi Akçelik,et al.  A review of gap-acceptance capacity models , 2007 .

[25]  Lawrence. Davis,et al.  Handbook Of Genetic Algorithms , 1990 .

[26]  M. Baucus.  Transportation Research Board , 1982 .

[27]  Sam Yagar,et al.  Systemwide Analysis of Freeway Improvements , 1996 .

[28]  Elzbieta Macioszek,et al.  Geometrical Determinants of Car Equivalents for Heavy Vehicles Crossing Circular Intersections , 2012, TST.

[29]  Orazio Giuffrè,et al.  Traffic simulation models calibration using speed-density relationship: An automated procedure based on genetic algorithm , 2016, Expert Syst. Appl..

[30]  Weng Tat Chan,et al.  ROAD-MAINTENANCE PLANNING USING GENETIC ALGORITHMS. II: ANALYSIS , 1994 .

[31]  Weng Tat Chan,et al.  Road-maintenance planning using genetic algorithms. I: Formulation , 1994 .

[32]  Francois Dion,et al.  Predicting Multimodal Roundabout Operations by Combining Deterministic and Micro-Simulation Models , 2012 .

[33]  Carlos Sun,et al.  Microsimulation Calibration Using Speed-Flow Relationships , 2008 .

[34]  Abishai Polus,et al.  A revised method for the determination of passenger car equivalencies , 1980 .

[35]  John Morrall,et al.  PASSENGER CAR EQUIVALENCIES OF TRUCKS, BUSES, AND RECREATIONAL VEHICLES FOR TWO-LANE RURAL HIGHWAYS , 1976 .

[36]  Paul Schonfeld,et al.  A highway alignment optimization model using geographic information systems , 2004 .

[37]  Kun Zhang,et al.  Modelling a complex give-way situation: AIMSUN vs LINSIG [roundabout] , 2013 .

[38]  J. Barceló.  Fundamentals of traffic simulation , 2010 .

[39]  Eric L. Keller,et al.  Passenger Car Equivalents From Network Simulation , 1984 .

[40]  Eric Monfroy,et al.  Autonomous Search , 2012, Springer Berlin Heidelberg.

[41]  Bruce Robinson,et al.  Roundabouts : an informational guide , 2000 .

[42]  David W. Corne,et al.  Structural bias in population-based algorithms , 2014, Inf. Sci..

[43]  Youn-Soo Kang,et al.  Comparing Calibration Methods for Microscopic Traffic Simulation Models , 2010 .

[44]  Geetam Tiwari,et al.  Estimation of PCE values for hill roads in heterogeneous traffic conditions , 2018 .

[45]  Saeid Nahavandi,et al.  A genetic algorithm-based method for improving quality of travel time prediction intervals , 2011 .

[46]  Ana Bastos Silva,et al.  Performance Assessment of Turbo-roundabouts in Corridors☆ , 2015 .

[47]  Orazio Giuffrè,et al.  Microsimulation-based passenger car equivalents for heavy vehicles driving turbo-roundabouts , 2016 .

[48]  M. J. Huber,et al.  ESTIMATION OF PASSENGER-CAR EQUIVALENTS OF TRUCKS IN TRAFFIC STREAM (DISCUSSION AND CLOSURE) , 1982 .

[49]  L. Hedges,et al.  Introduction to Meta‐Analysis , 2009, International Coaching Psychology Review.

[50]  Rune Elvik,et al.  Publication bias and time-trend bias in meta-analysis of bicycle helmet efficacy: a re-analysis of Attewell, Glase and McFadden, 2001. , 2011, Accident; analysis and prevention.

[51]  Ahmed Al-Kaisy.  Passenger Car Equivalents for Heavy Vehicles at Freeways and Multilane Highways: Some Critical Issues , 2006 .

[52]  Fan Tao,et al.  Using GIS and genetic algorithm in highway alignment optimization , 2003, Proceedings of the 2003 IEEE International Conference on Intelligent Transportation Systems.

[53]  Andreas Tapani,et al.  Comparison of car-following models , 2004 .

[54]  Chris Lee,et al.  Empirical Estimation of Capacity for Roundabouts Using Adjusted Gap-Acceptance Parameters for Trucks , 2012 .

[55]  Ola Hagring.  A further generalization of Tanner’s formula , 1998 .

[56]  Rubio-MartínJuan Luis,et al.  Heuristic procedure for the optimization of speed consistency in the geometric design of single-lane roundabouts , 2015 .

[57]  R. R. Saldanha,et al.  Improvements in genetic algorithms , 2001 .

[58]  Scott S. Washburn,et al.  Modification of the Highway Capacity Manual two‐lane highway analysis procedure for Spanish conditions , 2016 .

[59]  Thomas Bäck,et al.  Evolutionary algorithms in theory and practice - evolution strategies, evolutionary programming, genetic algorithms , 1996 .

[60]  Tarek Sayed,et al.  A comparison between PARAMICS and VISSIM in estimating automated field‐measured traffic conflicts at signalized intersections , 2016 .

[61]  Y C Hu,et al.  PASSENGER-CAR EQUIVALENTS OF TRUCKS IN COMPOSITE TRAFFIC , 1981 .

[62]  Chris Lee,et al.  Developing Passenger-Car Equivalents for Heavy Vehicles in Entry Flow at Roundabouts , 2015 .

[63]  Justin Geistefeldt,et al.  Estimation of Passenger Car Equivalents Based on Capacity Variability , 2009 .

[64]  Jurijs Merkurjevs,et al.  Analysis of Simulation Input and Output to Compare Simulation Tools , 2009 .

[65]  Orazio Giuffrè,et al.  Handling Underdispersion in Calibrating Safety Performance Function at Urban, Four-Leg, Signalized Intersections , 2011 .

[66]  Alexander Skabardonis,et al.  Traffic Analysis Toolbox Volume III: Guidelines for Applying Traffic Microsimulation Modeling Software , 2004 .

[67]  Michael Mawdesley,et al.  A Genetic Algorithm Approach to a 3D Highway Alignment Development , 2010, IJCCI.

[68]  R. M. Kimber.  Gap-Acceptance and Empiricism in Capacity Prediction , 1989, Transp. Sci..

[69]  Philippe Rigo,et al.  A review on simulation-based optimization methods applied to building performance analysis , 2014 .

[70]  Samuel Labi,et al.  Using Lagging Headways to Estimate Passenger Car Equivalents on Basic Freeway Sections , 2011 .

[71]  R A Krammes,et al.  PASSENGER CAR EQUIVALENTS FOR TRUCKS ON LEVEL FREEWAY SEGMENTS , 1986 .

[72]  Hideki Nakamura,et al.  An Analysis of Heavy Vehicle Impact on Roundabout Entry Capacity in Japan , 2016 .

[73]  Lily Elefteriadou,et al.  A simulation study of truck passenger car equivalents (PCE) on basic freeway sections , 1999 .

[74]  Melanie Mitchell,et al.  An introduction to genetic algorithms , 1996 .

[75]  Muhammad Adnan,et al.  Passenger car equivalent factors in heterogenous traffic environment-are we using the right numbers? , 2014 .

[76]  Md. Khaledur Rahman,et al.  Transit network design by genetic algorithm with elitism , 2014 .

[77]  A. E. Eiben,et al.  Parameter tuning for configuring and analyzing evolutionary algorithms , 2011, Swarm Evol. Comput..

[78]  Hesham A Rakha,et al.  Developing Passenger Car Equivalency Factors for Heavy Vehicles During Congestion , 2005 .