论文信息 - Fabrication of ZrO2–NiCr functionally graded material by powder metallurgy

Fabrication of ZrO2–NiCr functionally graded material by powder metallurgy

Abstract ZrO2–NiCr functionally graded material (FGM) was developed by powder metallurgical process. After investigating the preforming and sintering process of mixed powders with different compositions, the suitable fabrication procedure of FGM was determined. Microscopic observations demonstrate that the chemical composition and microstructure of ZrO2–NiCr FGM distribute gradually in stepwise way, eliminating the macroscopic ceramic/metal interface such as that in traditional ceramic/metal joint. The mechanical properties of ZrO2–NiCr system strongly depend on constitutional variation, and display various graded distributions as well.

[1] Jingchuan Zhu,et al. Fabrication and microstructure of ZrO2-Ni functional gradient material by powder metallurgy , 1996 .

[2] Ryuzo Watanabe,et al. Functionally gradient materials. In pursuit of super heat resisting materials for spacecraft. , 1987 .

[3] F. Lange. Transformation toughening , 1982 .

[4] S. Y. Lee,et al. Mechanical Performance of ZrO2-Ni Functionally Graded Material by Powder Metallurgy , 1997 .

[5] Yoshinari Miyamoto,et al. Functionally Graded Materials. , 1995 .

[6] B. H. Rabin,et al. Functionally Gradient Materials , 1995 .

[7] R. Watanabe,et al. Microstructural designing and fabrication of disk shaped functionally gradient material by powder metallurgy. , 1990 .

[8] M. Gasgnier. Phase Transitions and Microstructures of: a) Zirconia Ceramics as: ZrO2-MxOy (M=Y, Sc, Mg, Al and Mullite) Systems; b) Alumina and AlxMyOz Systems , 1992 .

[9] K. S. Ramesh,et al. Modelling studies applied to functionally graded materials , 1995 .