Parametrical analysis of the design and performance of a solar heat pipe thermoelectric generator unit

This paper describes a solar heat pipe thermoelectric generator (SHP-TEG) unit comprising an evacuated double-skin glass tube, a finned heat pipe and a TEG module. The system takes the advantage of heat pipe to convert the absorbed solar irradiation to a high heat flux to meet the TEG operating requirement. An analytical model of the SHP-TEG unit is presented for the condition of constant solar irradiation, which may lead to different performance characteristics and optimal design parameters compared with the condition of constant temperature difference usually dealt with in other studies. The analytical model presents the complex influence of basic parameters such as solar irradiation, cooling water temperature, thermoelement length and cross-section area and number of thermoelements, etc. on the maximum power output and conversion efficiency of the SHP-TEG. Simulation based on the analytical model has been carried out to study the performance and design optimization of the SHP-TEG.

[1]  Jianlin Yu,et al.  A numerical model for thermoelectric generator with the parallel-plate heat exchanger , 2007 .

[2]  Jianlin Yu,et al.  Experimental study on low-temperature waste heat thermoelectric generator , 2009 .

[3]  E. Azad,et al.  Theoretical and experimental investigation of heat pipe solar collector , 2008 .

[4]  Tin-Tai Chow,et al.  A Review on Photovoltaic/Thermal Hybrid Solar Technology , 2010, Renewable Energy.

[5]  L. P. Bulat,et al.  Thermal-photovoltaic solar hybrid system for efficient solar energy conversion , 2006 .

[6]  Cheng-Ting Hsu,et al.  Experiments and simulations on low-temperature waste heat harvesting system by thermoelectric power generators , 2011 .

[7]  James W. Stevens,et al.  Optimal design of small ΔT thermoelectric generation systems , 2001 .

[8]  Philip C. Eames,et al.  Experimental investigation of natural convection heat exchange within a physical model of the manifold chamber of a thermosyphon heat-pipe evacuated tube solar water heater , 2009 .

[9]  Xiaolong Gou,et al.  Modeling, experimental study and optimization on low-temperature waste heat thermoelectric generator system , 2010 .

[10]  Hongxia Xi,et al.  Development and applications of solar-based thermoelectric technologies , 2007 .

[11]  Gao Min,et al.  Evaluation of thermoelectric modules for power generation , 1998 .

[12]  Fengrui Sun,et al.  Performance optimization of a two-stage semiconductor thermoelectric-generator , 2005 .

[13]  Fengrui Sun,et al.  Effect of heat transfer on the performance of thermoelectric generators , 2002 .

[14]  Gunter Rockendorf,et al.  PV-hybrid and thermoelectric collectors , 1999 .

[15]  G. Jackson,et al.  Optimization of cross flow heat exchangers for thermoelectric waste heat recovery , 2004 .

[16]  David Infield,et al.  Design and thermal analysis of a two stage solar concentrator for combined heat and thermoelectric power generation , 2000 .

[17]  Jean-Pierre Bédécarrats,et al.  Thermoelectric power generation from biomass cook stoves , 2010 .

[18]  D. Infield,et al.  Design optimization of thermoelectric devices for solar power generation , 1998 .