Platform Architecture for Solar, Thermal, and Vibration Energy Combining With MPPT and Single Inductor

A platform architecture combining energy from solar, thermal, and vibration sources is presented. A dual-path architecture for energy harvesting is employed that has a peak efficiency improvement of 11%-13% over the traditional two-stage approach. The system implemented consists of a reconfigurable multi-input, multi-output switch matrix that combines energy from three distinct energy-harvesting sources-photovoltaic, thermoelectric, and piezoelectric. The system can handle input voltages from 20 mV to 5 V and is capable of extracting maximum power from individual harvesters all at the same time utilizing a single inductor. A proposed time-based power monitor is used for achieving maximum power point tracking for the photovoltaic harvester. This has a peak tracking efficiency of 96%. The peak efficiencies achieved with inductor sharing are 83%, 58%, and 79% for photovoltaic boost, thermoelectric boost, and piezoelectric buck-boost converters, respectively. The switch matrix and the control circuits are implemented on a 0.35-μm CMOS process.

[1]  Anantha Chandrakasan,et al.  A Battery-Less Thermoelectric Energy Harvesting Interface Circuit With 35 mV Startup Voltage , 2010, IEEE Journal of Solid-State Circuits.

[2]  Chris Van Hoof,et al.  5μW-to-10mW input power range inductive boost converter for indoor photovoltaic energy harvesting with integrated maximum power point tracking algorithm , 2010, 2011 IEEE International Solid-State Circuits Conference.

[3]  Julien Penders,et al.  Energy Harvesting for Autonomous Wireless Sensor Networks , 2010, IEEE Solid-State Circuits Magazine.

[4]  P.L. Chapman,et al.  Comparison of Photovoltaic Array Maximum Power Point Tracking Techniques , 2007, IEEE Transactions on Energy Conversion.

[5]  Heath Hofmann,et al.  Adaptive piezoelectric energy harvesting circuit for wireless, remote power supply , 2001 .

[6]  Anantha Chandrakasan,et al.  Platform architecture for solar, thermal and vibration energy combining with MPPT and single inductor , 2011, 2011 Symposium on VLSI Circuits - Digest of Technical Papers.

[7]  J.J. Schoeman,et al.  A simplified maximal power controller for terrestrial photovoltaic panel arrays , 1982, 1982 IEEE Power Electronics Specialists conference.

[8]  Anantha Chandrakasan,et al.  An efficient piezoelectric energy-harvesting interface circuit using a bias-flip rectifier and shared inductor , 2009, 2009 IEEE International Solid-State Circuits Conference - Digest of Technical Papers.

[9]  Richard T. Witek,et al.  A 160 MHz 32 b 0.5 W CMOS RISC microprocessor , 1996, 1996 IEEE International Solid-State Circuits Conference. Digest of TEchnical Papers, ISSCC.

[10]  C. Van Hoof,et al.  Wearable Autonomous Wireless Electro-encephalography System Fully Powered by Human Body Heat , 2008, 2008 IEEE Sensors.

[11]  Charles R. Sullivan,et al.  A high-efficiency maximum power point tracker for photovoltaic arrays in a solar-powered race vehicle , 1993, Proceedings of IEEE Power Electronics Specialist Conference - PESC '93.

[12]  Cyril Condemine,et al.  Efficient Power Management Circuit: From Thermal Energy Harvesting to Above-IC Microbattery Energy Storage , 2008, IEEE J. Solid State Circuits.

[13]  Leon O. Chua,et al.  Nonlinear resistive maximum power theorem, with solar cell application , 1983 .

[14]  David Blaauw,et al.  Millimeter-scale nearly perpetual sensor system with stacked battery and solar cells , 2010, 2010 IEEE International Solid-State Circuits Conference - (ISSCC).

[15]  Chihchiang Hua,et al.  Comparative study of peak power tracking techniques for solar storage system , 1998, APEC '98 Thirteenth Annual Applied Power Electronics Conference and Exposition.

[16]  Stephen H. Lewis,et al.  An energy-aware multiple-input power supply with charge recovery for energy harvesting applications , 2009, 2009 IEEE International Solid-State Circuits Conference - Digest of Technical Papers.

[17]  Charles R. Sullivan,et al.  Synchronous rectification with adaptive timing control , 1995, Proceedings of PESC '95 - Power Electronics Specialist Conference.

[18]  Kai Strunz,et al.  A 20 mV Input Boost Converter With Efficient Digital Control for Thermoelectric Energy Harvesting , 2010, IEEE Journal of Solid-State Circuits.

[19]  J. Kwong,et al.  An Energy-Efficient Biomedical Signal Processing Platform , 2010, IEEE Journal of Solid-State Circuits.

[20]  Yogesh K. Ramadass.  Energy processing circuits for low-power applications , 2009 .