Mobile transmitter digital predistortion: Feasibility analysis, algorithms and design exploration

This article addresses intermodulation challenges in carrier aggregation (CA) and multicluster type transmission scenarios in mobile transmitters. In such transmission schemes, emerging in 3GPP LTE-Advanced mobile cellular radio evolution, the spectrum of the signal entering the transmit power amplifier (PA) is of non-contiguous nature and thus severe intermodulation is created which may violate the spurious emission mask. To satisfy the stringent emission requirements and limits, devices may need to considerably back off their transmit power, compared to nominal value of ;23dBm, but this will reduce the uplink coverage. As an alternative, feasibility of digital predistortion (DPD) is explored in this article. A DPD solution is developed to control the most critical intermodulation components from terminal emission mask perspective with reduced complexity compared to conventional DPD solutions. The DPD is based on the Augmented Parallel Hammerstein (APH) architecture which can handle IQ imbalance and local oscillator leakage in addition to the PA nonlinearity while using simple digital linear estimation techniques. Furthermore, digital design exploration is carried out for the predistortion algorithm, implying that the needed computational resources are close to what is already available in most advanced mobile platforms and chipsets in the market.

[1]  William J. Dally,et al.  Explaining the gap between ASIC and custom power: a custom perspective , 2005, Proceedings. 42nd Design Automation Conference, 2005..

[2]  Shuvra S. Bhattacharyya,et al.  A Lightweight Dataflow Approach for Design and Implementation of SDR Systems , 2010 .

[3]  Jarmo Takala,et al.  Customized Exposed Datapath Soft-Core Design Flow with Compiler Support , 2010, 2010 International Conference on Field Programmable Logic and Applications.

[4]  Markku J. Juntti,et al.  Fixed- and Floating-Point Processor Comparison for MIMO-OFDM Detector , 2011, IEEE Journal of Selected Topics in Signal Processing.

[5]  Shan Tang,et al.  A 100 GOPS ASP based baseband processor for wireless communication , 2013, DATE.

[6]  Steve C. Cripps,et al.  Advanced Techniques in RF Power Amplifier Design , 2002 .

[7]  A. Katz,et al.  Truly wideband linearization , 2009, IEEE Microwave Magazine.

[8]  Cornelis Jan Kikkert,et al.  Adaptive Digital Predistortion for Wideband High Crest Factor Applications Based on the WACP Optimization Objective: A Conceptual Overview , 2012, IEEE Transactions on Broadcasting.

[9]  Mikko Valkama,et al.  Gating factor analysis of maximum power reduction in multicluster LTE-A uplink transmission , 2013, 2013 IEEE Radio and Wireless Symposium.

[10]  Toni Lähteensuo Linearity Requirements in LTE-Advanced Mobile Transmitter , 2013 .

[11]  Danijela Cabric,et al.  A 7.4mW 200MS/s wideband spectrum sensing digital baseband processor for cognitive radios , 2011, 2011 Symposium on VLSI Circuits - Digest of Technical Papers.

[12]  Danijela Cabric,et al.  A 7.4-mW 200-MS/s Wideband Spectrum Sensing Digital Baseband Processor for Cognitive Radios , 2012, IEEE Journal of Solid-State Circuits.

[13]  Dursun Baran,et al.  Energy efficient implementation of parallel CMOS multipliers with improved compressors , 2010, 2010 ACM/IEEE International Symposium on Low-Power Electronics and Design (ISLPED).

[14]  Mikko Valkama,et al.  Joint Mitigation of Power Amplifier and I/Q Modulator Impairments in Broadband Direct-Conversion Transmitters , 2010, IEEE Transactions on Microwave Theory and Techniques.