Preliminary study on mechanism of cavitation in lubricant of textured sliding bearing

The mechanism of the cavitation in a lubricant of a textured sliding bearing is studied based on multiphase flow theories and tribological equations. First, a physical model for a bearing with a series of semi-spherical dimples is modeled through commercial software ANSYS. Then, influences of dimple position and sizes on the vapor volume fraction, and cavitated area of the bearing are studied with computational fluid dynamic method. Numerical results show that the obvious fluctuation of the vapor volume rate and changes in the starting and end angles of the cavitation region due to varied dimple position can occur, when the dimples are located in the cavitated region. Moreover, with increasing cavitation starting angle, the changing trend of the cavitated area is the same as that of the load-carrying capacity, but opposite to the variation trends of the friction force and further friction coefficient.

[1]  Fanming Meng,et al.  Study on effect of dimples on friction of parallel surfaces under different sliding conditions , 2010 .

[2]  Sergei Glavatskih,et al.  Computational fluid dynamics analysis of a journal bearing with surface texturing , 2008 .

[3]  Cem Sinanoğlu,et al.  Effects of shaft surface texture on journal bearing pressure distribution , 2005 .

[4]  Shuji Sakaguchi,et al.  Tribological properties of dimpled silicon nitride under oil lubrication , 2004 .

[5]  Patrick Maspeyrot,et al.  Effect of textured area on the performances of a hydrodynamic journal bearing , 2011 .

[6]  Roland Larsson,et al.  Two-Dimensional CFD-Analysis of Micro-Patterned Surfaces in Hydrodynamic Lubrication , 2005 .

[7]  Hugh Spikes,et al.  ‘Inlet suction’, a load support mechanism in non-convergent, pocketed, hydrodynamic bearings , 2006 .

[8]  M Fillon,et al.  Effects of surface texture on journal-bearing characteristics under steady-state operating conditions , 2007 .

[9]  Michael M. Khonsari,et al.  On the Prediction of Cavitation in Dimples Using a Mass-Conservative Algorithm , 2009 .

[10]  M. Fillon,et al.  Analytical investigation of a partially textured parallel slider , 2009 .

[11]  Michael M. Khonsari,et al.  Performance Analysis of Full-Film Textured Surfaces With Consideration of Roughness Effects , 2011 .

[12]  Xi Shi,et al.  Effects of groove textures on fully lubricated sliding with cavitation , 2011 .

[13]  Sergei Glavatskih,et al.  3D thermohydrodynamic analysis of a textured slider , 2009 .

[14]  Yoshiteru Yasuda,et al.  Effect of surface texturing on friction reduction between ceramic and steel materials under lubricated sliding contact , 2003 .

[15]  and D Dowson,et al.  Cavitation in Bearings , 1979 .

[16]  S. Ge,et al.  Hydrodynamic Lubrication of Microdimple Textured Surface Using Three-Dimensional CFD , 2010 .

[17]  Pantelis G. Nikolakopoulos,et al.  Geometry Optimization of Textured Three-Dimensional Micro- Thrust Bearings , 2011 .