1V transimpedance amplifier in 90nm CMOS for medical ultrasound imaging

In this paper we present the measurement results of a 1V transimpedance amplifier designed in a 90nm CMOS technology as an analog front-end for Capacitive Micro machined Ultrasound Transducers (CMUTs) for medical ultrasound imaging. The proposed amplifier is designed to amplify the signals from 15MHz to 45MHz with a center frequency of 30MHz. The measurements show that the proposed amplifier achieves a voltage gain of 15.5 dB, an output noise power spectral density of 0.0497 (µV)/SQRT(Hz) at a center-frequency of 30 MHz, and a total harmonic distortion of −28.8 dB, at 400mV p-p output voltage at 30 MHz input signal frequency. It draws only 450 µA current from a 1-V power supply. The proposed transimpedance amplifier was fabricated in a 90-nm CMOS technology as it is intended for intravenous medical ultrasound imaging, which demands smaller area for the front-end amplifiers. Area measured to be about 26 µm × 26 µm only per amplifier.

[1]  B. Nauta,et al.  Analog circuits in ultra-deep-submicron CMOS , 2005, IEEE Journal of Solid-State Circuits.

[2]  R. van Langevelde,et al.  Designing outside rail constraints , 2004, 2004 IEEE International Solid-State Circuits Conference (IEEE Cat. No.04CH37519).

[3]  David A. Johns,et al.  Analog Integrated Circuit Design , 1996 .

[4]  Alan B. Grebene,et al.  Analog Integrated Circuit Design , 1978 .

[5]  O. Oralkan,et al.  Integrated ultrasonic imaging systems based on CMUT arrays: recent progress , 2004, IEEE Ultrasonics Symposium, 2004.

[6]  D. Hutchins,et al.  Low-temperature micromachined cMUTs with fully-integrated analogue front-end electronics , 2002, 2002 IEEE Ultrasonics Symposium, 2002. Proceedings..

[7]  D.D. Buss.  Technology in the Internet age , 2002, 2002 IEEE International Solid-State Circuits Conference. Digest of Technical Papers (Cat. No.02CH37315).

[8]  A. Ronnekleiv,et al.  Fabrication and Characterization of CMUTs realized by Wafer Bonding , 2006, 2006 IEEE Ultrasonics Symposium.

[9]  D. Hutchins,et al.  Cost-effective and manufacturable route to the fabrication of high-density 2D micromachined ultrasonic transducer arrays and (CMOS) signal conditioning electronics on the same silicon substrate , 2001, 2001 IEEE Ultrasonics Symposium. Proceedings. An International Symposium (Cat. No.01CH37263).

[10]  Jin Fan,et al.  Integrated amplifier with active limiter for intravascular ultrasonic imaging , 2004, Circuits, Signals, and Systems.

[11]  Yuan Taur,et al.  CMOS design near the limit of scaling , 2002 .