Analysis of critical-length data from Electromigration failure studies

Abstract An accurate estimation of the Blech length, the critical line length below which interconnect lines are immortal, is vital as it allows EDA tools to reduce their workload. In lines longer than the Blech length, either a void will inevitably nucleate and grow until the line fails, or the line will rupture. The majority of failure analyses reveal voiding as the failure mechanism however recent analysis suggest Blech length failures are characterised by simultaneous [6] voiding and rupture, and a non-zero steady-state drift velocity. This paper provides an alternative interpretation of results.

[1]  E. Kinsbron,et al.  Electromigration in thin gold films on molybdenum surfaces , 1975 .

[2]  Ping-Chuan Wang,et al.  Electromigration threshold in single-damascene copper interconnects with SiO/sub 2/ dielectrics , 2001, Proceedings of the IEEE 2001 International Interconnect Technology Conference (Cat. No.01EX461).

[3]  Ping-Chuan Wang,et al.  Electromigration threshold in copper interconnects , 2001 .

[4]  Tahui Wang,et al.  Effects of width scaling and layout variation on dual damascene copper interconnect electromigration , 2007, Microelectron. Reliab..

[5]  Tahui Wang,et al.  Effects of length scaling on electromigration in dual-damascene copper interconnects , 2008, Microelectron. Reliab..

[6]  X. Federspiel,et al.  Stress-induced electromigration backflow effect in copper interconnects , 2006, IEEE Transactions on Device and Materials Reliability.

[7]  Paul S. Ho,et al.  Electromigration reliability issues in dual-damascene Cu interconnections , 2002, IEEE Trans. Reliab..

[8]  A.S. Oates,et al.  Electromigration Failure Distributions of Cu/Low-$k$ Dual-Damascene Vias: Impact of the Critical Current Density and a New Reliability Extrapolation Methodology , 2009, IEEE Transactions on Device and Materials Reliability.

[9]  Carl V. Thompson,et al.  Dependence of the electromigration flux on the crystallographic orientations of different grains in polycrystalline copper interconnects , 2007 .

[10]  G. S. Cargill,et al.  Electromigration-induced stress in aluminum conductor lines measured by x-ray microdiffraction , 1998 .

[11]  Paul S. Ho,et al.  Electromigration critical length effect in Cu/oxide dual-damascene interconnects , 2001 .

[12]  T. Marieb,et al.  Electromigration lifetime and critical void volume , 2004 .

[13]  A. S. Oates,et al.  Void nucleation and growth contributions to the critical current density for failure of Cu vias , 2009, 2009 IEEE International Reliability Physics Symposium.

[14]  James R. Lloyd,et al.  Electromigration and mechanical stress , 1999 .

[15]  M. Korhonen,et al.  Stress evolution due to electromigration in confined metal lines , 1993 .

[16]  Kim Y. Lee,et al.  Electromigration and stress-induced voiding in fine Al and Al-alloy thin-film lines , 1995, IBM J. Res. Dev..

[17]  R. Rosenberg,et al.  Capping Layer Effects on Electromigration in Narrow Cu Lines , 2004 .

[18]  J. Jordan-Sweet,et al.  Real-time x-ray microbeam characterization of electromigration effects in Al(Cu) wires , 2001 .

[19]  Paul S. Ho,et al.  Direct observation of a critical length effect in dual-damascene Cu/oxide interconnects , 2001 .

[20]  Paul S. Ho,et al.  Electromigration reliability of dual-damascene Cu/porous methylsilsesquioxane low k interconnects , 2003 .

[21]  L. Arnaud,et al.  Electromigration induced void kinetics in Cu interconnects for advanced CMOS nodes , 2011, 2011 International Reliability Physics Symposium.