Nesting of complex sheet metal parts

AbstractIn the mass production of sheet metal parts, saving of materials is very important as material cost is the major portion of the overall production cost. By making use of the Minkowski sum evaluation, efficient nesting of part blanks is achieved. In the part layout formation, strip pitch and width are calculated for different blank-pair orientations. The optimum orientation of two nested pairs that results in the greatest material utilization is then obtained. These algorithms for nesting and part layout formation are implemented in SolidWorks and some case studies carried out on typical parts to demonstrate the method are discussed. It was found that for parts that have the Minkowski sum inner loop, a very high material utilization can be achieved.

[1]  Pankaj K. Agarwal,et al.  Polygon Decomposition for Efficient Construction of Minkowski Sums , 2000, ESA.

[2]  Moises Sudit,et al.  PROCEDURES FOR SOLVING SINGLE-PASS STRIP LAYOUT PROBLEMS , 1994 .

[3]  Blas Pelegrín,et al.  Algorithms for the decomposition of a polygon into convex polygons , 2000, Eur. J. Oper. Res..

[4]  Chul Kim,et al.  An integrated CAD system for the blanking of irregular-shaped sheet metal products , 1998 .

[5]  Gershon Elber,et al.  Polynomial/Rational Approximation of Minkowski Sum Boundary Curves , 1998, Graph. Model. Image Process..

[6]  K.K.B. Hon,et al.  Automated Design of Progressive Dies , 1996 .

[7]  K.K.B. Hon,et al.  New approaches for the nesting of two-dimensional shapes for press tool design , 1992 .

[8]  John F. Raffensperger,et al.  An improved method for calculating the no-fit polygon , 2006, Comput. Oper. Res..

[9]  R. Gomory,et al.  Multistage Cutting Stock Problems of Two and More Dimensions , 1965 .

[10]  Joseph O'Rourke,et al.  Computational Geometry in C. , 1995 .

[11]  T. J. Nye.  Stamping strip layout for optimal raw material utilization , 2000 .

[12]  Dov Dori,et al.  Efficient nesting of congruent convex figures , 1984, CACM.

[13]  T. J. Nye,et al.  Stamping Die Strip Optimization for Paired Parts , 2002 .

[14]  Yinghong Peng,et al.  Development of a Practical Blank Layout Optimisation System for Stamping Die Design , 2002 .

[15]  Antonio Albano,et al.  NESTING TWO-DIMENSIONAL SHAPES IN RECTANGULAR MODULES , 1976 .

[16]  Ralph E. Gomory,et al.  A Linear Programming Approach to the Cutting Stock Problem---Part II , 1963 .