Comparison of Experimental results with CFD for NREL Phase VI Rotor with Tip Plate

This article presents the results of 3D CFD rotor computations of a NREL Phase VI rotor with tip plate, a stall-regulated turbine with full-span pitch control, has a power rating of 20 kW. In this paper, A full three dimensional CFD–RANS approach by modeling the whole rotor of a wind turbine by means of periodicity was used. All the simulations were performed using the commercial multi-purpose CFD solver ANSYS CFX 12.1 with the transition model of Langtry and Menter is applied to a rotor at stationary wind conditions without wind shear. The comparisons were done for the blade with 0° yaw angle and 3° tip pitch angle on a single rotor blade without tower and nacelle. Reasonably good agreement is obtained when comparing modeled mechanical effects like power and thrust with findings from measurements. Similarly the spanwise force distributions are compared with experimental results for two wind speeds along with pressure distributions at five different spanwise locations. It is shown capability of 3D CFD computations that can be used to extract information about three-dimensional aerodynamic effects.

[1]  F. Menter.  Two-equation eddy-viscosity turbulence models for engineering applications , 1994 .

[2]  Earl P. N. Duque,et al.  Navier-Stokes and Comprehensive Analysis Performance Predictions of the NREL Phase VI Experiment , 2003 .

[3]  Niels N. Sørensen,et al.  Navier-Stokes predictions of the NREL phase VI rotor in the NASA Ames 80-by-120 wind tunnel , 2002 .

[4]  D. Mavriplis,et al.  Unstructured Mesh CFD Aerodynamic Analysis of the NREL Phase VI Rotor , 2009 .

[5]  C. P. van Dam,et al.  Computational aerodynamic analysis of a blunt trailing‐edge airfoil modification to the NREL Phase VI rotor , 2007 .

[6]  Christian Bak,et al.  Development of the Risø wind turbine airfoils , 2004 .

[7]  C. P. van Dam,et al.  Aerodynamic Analysis of Blunt Trailing Edge Airfoils , 2003 .

[8]  X Munduate,et al.  Three-dimensional and Rotational Aerodynamics on the NREL phase VI Wind Turbine Blade , 2007 .

[9]  Jeppe Johansen,et al.  Detached-Eddy Simulation of Flow Around the NREL Phase-VI Blade , 2002 .

[10]  Maureen Hand,et al.  NREL Unsteady Aerodynamics Experiment in the NASA-Ames Wind Tunnel: A Comparison of Predictions to Measurements , 2001 .

[11]  Jeppe Johansen,et al.  Wind turbine rotor-tower interaction using an incompressible overset grid method , 2009 .

[12]  Arnaud Le Pape,et al.  Improved Navier-Stokes Computations of a Stall-regulated Wind Turbine using Low Mach number Preconditioning , 2006 .

[13]  Jean-Jacques Chattot,et al.  Application of a 'Parallelized Coupled Navier -Stokes/Vortex - Panel Solver' to the NREL Phase VI Rotor , 2005 .

[14]  Jeppe Johansen,et al.  Tip studies using CFD and comparison with tip loss models , 2004 .

[15]  L. Fingersh.  Unsteady Aerodynamics Experiment , 2001 .

[16]  Jeppe Johansen,et al.  Aerodynamic investigation of winglets on wind turbine blades using CFD , 2006 .