Multi-Response Optimization Using Taguchi Method of Resistance Spot Welding Parameters

This paper presents the effects of spot welding parameters on multi-response weld quality and optimizes the governing parameters of Resistance Spot Welding (RSW) towards the tensile shear strength and nugget size using Taguchi method. The main affecting welding parameters such as electrode force, weld time and weld current were determined as the basis for quality evaluation. The selected quality features were classified into shear strength and nugget size which were required for application with highly dynamic loading. The optimum welding parameter was obtained using multi signal-to-noise ratio (MSNR) and the significant level of welding parameters was further analysed using analysis of variance (ANOVA). Based on the results, electrode force was found to be most effective parameter affecting shear strength and nugget size. The experiment was conducted at optimum welding parameter and validated the used of multi-objective Taguchi method for enhancing performance and optimizing the welding parameters in RSW process.

[1]  V. M. Nandedkar,et al.  Application of Taguchi method to determine resistance spot welding conditions of austenitic stainless steel AISI 304 , 2010 .

[2]  Yupiter Hp Manurung,et al.  Design Parameters Selection and Optimization of Weld Zone Development in Resistance Spot Welding , 2012 .

[3]  Yupiter Harangan Prasada Manurung,et al.  Optimization of Friction Stir Welding Parameters with Simultaneous Multiple Response Consideration Using Multi-Objective Taguchi Method , 2014 .

[4]  Y. Bozkurt,et al.  Application of Taguchi approach to optimize of FSSW parameters on joint properties of dissimilar AA2024-T3 and AA5754-H22 aluminum alloys , 2013 .

[5]  António Pereira,et al.  Effect of process parameters on the strength of resistance spot welds in 6082-T6 aluminium alloy , 2010 .

[6]  Ghalib Tham,et al.  Optimization and modeling of spot welding parameters with simultaneous multiple response consideration using multi-objective Taguchi method and RSM , 2012 .

[7]  Faramarz Ashenai Ghasemi,et al.  Optimization of process parameters for friction stir lap welding of carbon fibre reinforced thermoplastic composites by Taguchi method , 2014, Journal of Mechanical Science and Technology.

[8]  V. Yadava,et al.  Multi-objective optimisation of laser beam cutting process , 2008 .

[9]  Roseleena Jaafar,et al.  Model development for quality features of resistance spot welding using multi-objective Taguchi method and response surface methodology , 2013, J. Intell. Manuf..

[10]  Roseleena Jaafar,et al.  Modeling and Optimization of Weld Zone Development in Resistance Seam Welding , 2012 .