Investigation of passive DMFC mini-stacks at ambient temperature

Abstract Two designs of flow fields/current collectors for a passive direct methanol fuel cell (DMFC) monopolar three-cell stack were investigated. The first one (A) consisted of two plastic plates covered by thin gold film current collectors in the area of electrodes with a distribution of holes through which methanol (from a reservoir) and air (from ambient) could diffuse into the electrodes. The second design (B) consisted of thin gold film deposited on the external borders of the fuel and oxidant apertures where the electrodes were placed in contact. A big central hole allowed a direct exposure of electrodes to ambient air (for the cathodes) and methanol solution (for the anodes). An investigation of the performance and discharge behaviour of the two designs was carried out. The advantages and disadvantages of each configuration were analysed. Similar performances in terms of maximum power were recorded; whereas, better mass transport characteristics were obtained with the design B. On the contrary, open circuit voltage (OCV) and stack voltage at low current were higher for the design A as a consequence of lower methanol cross-over. A longer discharge time (17 h) with a unique MeOH charge was recorded with design B at 250 mA compared to the design A (5 h). This was attributed to an easier CO 2 removal from the anode and better mass transport properties.

[1]  Mohammad Ali Abdelkareem,et al.  Effect of oxygen and methanol supply modes on the performance of a DMFC employing a porous plate , 2007 .

[2]  Amir Faghri,et al.  Water and air management systems for a passive direct methanol fuel cell , 2007 .

[3]  Amir Faghri,et al.  Development of planar air breathing direct methanol fuel cell stacks , 2006 .

[4]  A. K. Shukla,et al.  A vapour-feed direct-methanol fuel cell with proton-exchange membrane electrolyte , 1995 .

[5]  Giuseppe D'Arrigo,et al.  Fabrication of miniaturized Si-based electrocatalytic membranes , 2003 .

[6]  Hong Chang,et al.  Materials and processes for small fuel cells , 2002 .

[7]  Antonino S. Aricò,et al.  DMFCs: From Fundamental Aspects to Technology Development , 2001 .

[8]  Qiang Ye,et al.  In situ visualization study of CO2 gas bubble behavior in DMFC anode flow fields , 2005 .

[9]  Y. H. Pan.  Advanced air-breathing direct methanol fuel cells for portable applications , 2006 .

[10]  Rong Chen,et al.  Performance characterization of passive direct methanol fuel cells , 2007 .

[11]  Jiujun Zhang,et al.  Design and testing of a passive planar three-cell DMFC , 2007 .

[12]  Shimshon Gottesfeld,et al.  High performance direct methanol polymer electrolyte fuel cells , 1996 .

[13]  Chaoyang Wang,et al.  Development and characterization of a silicon-based micro direct methanol fuel cell , 2004 .

[14]  Jun Shen,et al.  Architecture for portable direct liquid fuel cells , 2006 .

[15]  U. Stimming,et al.  Catalysts for Direct Methanol Fuel Cells , 2002 .

[16]  Passive air management for cylindrical cartridge fuel cells , 2007 .

[17]  Christopher K. Dyer.  Fuel cells for portable applications , 2002 .

[18]  Rong Chen,et al.  Porous current collectors for passive direct methanol fuel cells , 2007 .

[19]  Emanuel Peled,et al.  Water-neutral micro direct-methanol fuel cell (DMFC) for portable applications , 2003 .

[20]  Chao-Yang Wang,et al.  Electrochemical and flow characterization of a direct methanol fuel cell , 2004 .

[21]  William H. Smyrl,et al.  A Miniature Methanol/Air Polymer Electrolyte Fuel Cell , 1999 .

[22]  S. Wasmus,et al.  Methanol oxidation and direct methanol fuel cells: a selective review 1 In honour of Professor W. Vi , 1999 .

[23]  Fuqiang Liu,et al.  Low Crossover of Methanol and Water Through Thin Membranes in Direct Methanol Fuel Cells , 2006 .

[24]  S. Srinivasan,et al.  International activities in DMFC R&D: status of technologies and potential applications , 2004 .

[25]  Anders Oedegaard,et al.  Characterisation of direct methanol fuel cells under near-ambient conditions , 2006 .

[26]  In-Hwan Oh,et al.  Recent progress in passive direct methanol fuel cells at KIST , 2004 .

[27]  Rong Chen,et al.  A novel electrode architecture for passive direct methanol fuel cells , 2007 .

[28]  V. Antonucci,et al.  Investigation of grafted ETFE-based polymer membranes as alternative electrolyte for direct methanol fuel cells , 2003 .

[29]  Takeshi Ito,et al.  Characteristics of micro DMFCs array fabricated on flexible polymeric substrate , 2006 .

[30]  E. Modica,et al.  Development and operation of a 150 W air-feed direct methanol fuel cell stack , 2001 .

[31]  Jian Zhang,et al.  Influence of cathode oxygen transport on the discharging time of passive DMFC , 2008 .