Computational fluid dynamics modeling of subsonic flowing-gas diode-pumped alkali lasers: comparison with semi-analytical model calculations and with experimental results

Comprehensive analysis of kinetic and fluid dynamic processes in flowing-gas diode-pumped alkali lasers (DPALs) using two- and three-dimensional computational fluid dynamics (2D and 3D CFD) models is reported. The 2D model is applied to a Cs DPAL with optical resonator-flow field coaxial configuration and the 3D model is applied to an optical axis transverse to the flow configuration. The models take into account effects of temperature rise and losses of Cs atoms due to ionization. The 2D CFD model is applied to 1 kW flowing-gas Cs DPAL [Quantum Electron.42, 95 (2012)10.1070/QE2012v042n02ABEH014734QUELEZ1063-7818] and the calculated results are in good agreement with the measurements. Comparison of the 2D CFD to semi-analytical model [J. Opt. Soc. Am. B30, 1118 (2013)10.1364/JOSAB.30.001118JOBPDE0740-3224] shows that for low pump power both models predict very close values of the laser power; however, at higher pump power, corresponding to saturation of the absorption of the pump transition, the laser power calculated using the 2D CFD model is much higher than that obtained using the semi-analytical model. At high pump power, the heat convection out of the laser resonator is more efficient for the transverse case than the coaxial case, the temperature in the resonator is lower, and consequently the calculated laser power is higher. Optimization of the Cs DPAL parameters, using 3D CFD modeling, shows that applying high flow velocity and narrowband pumping, maximum lasing power as high as 40 kW can be obtained at pump power of 80 kW for transverse flow configuration in a pumped volume of ∼0.7  cm3.

[1]  Karol Waichman,et al.  Kinetic and fluid dynamic processes in diode pumped alkali lasers: semi-analytical and 2D and 3D CFD modeling , 2014, Photonics West - Lasers and Applications in Science and Engineering.

[2]  V. K. Kanz,et al.  End-pumped continuous-wave alkali vapor lasers: experiment, model, and power scaling , 2004 .

[3]  Weihong Hua,et al.  Theoretical model and novel numerical approach of a broadband optically pumped three-level alkali vapour laser , 2011 .

[4]  Boris V. Zhdanov,et al.  Multiple laser diode array pumped Cs laser with 48W output power , 2008 .

[5]  David L. Carroll,et al.  Role of excited state photoionization in the 852.1 nm Cs laser pumped by Cs-Ar photoassociation , 2013 .

[6]  Xiaojun Xu,et al.  Modeling, numerical approach, and power scaling of alkali vapor lasers in side-pumped configuration with flowing medium , 2011 .

[7]  Boris V. Zhdanov,et al.  Review of alkali laser research and development , 2012 .

[8]  B. Barmashenko,et al.  Analysis of lasing in gas-flow lasers with stable resonators. , 1998, Applied optics.

[9]  G. Perram,et al.  A three-level analytic model for alkali metal vapor lasers: part I. Narrowband optical pumping , 2010 .

[10]  M. K. Shaffer,et al.  Photoionization in alkali lasers. , 2011, Optics express.

[11]  Jason Zweiback,et al.  Alkali-vapor lasers , 2010, LASE.

[12]  William F. Krupke,et al.  Diode pumped alkali lasers (DPALs)—A review (rev1) , 2012 .

[13]  Mohamed S. El-Genk,et al.  Dissociative recombination coefficient for low temperature equilibrium cesium plasma , 2002 .

[14]  Boris D. Barmashenko,et al.  Detailed analysis of kinetic and fluid dynamic processes in diode-pumped alkali lasers , 2013 .

[15]  V. A. Eroshenko,et al.  Diode-pumped caesium vapour laser with closed-cycle laser-active medium circulation , 2012 .

[16]  Karol Waichman,et al.  Semi-analytical and 3D CFD DPAL modeling: feasibility of supersonic operation , 2014, Photonics West - Lasers and Applications in Science and Engineering.

[17]  Luc Barbier,et al.  Experimental study of Penning and Hornbeck-Molnar ionisation of rubidium atoms excited in a high s or d level (5d⩽nl⩽11s) , 1987 .

[18]  G. Perram,et al.  A three-level model for alkali metal vapor lasers. Part II: broadband optical pumping , 2013 .

[19]  B. Barmashenko,et al.  Modeling of flowing gas diode pumped alkali lasers: dependence of the operation on the gas velocity and on the nature of the buffer gas. , 2012, Optics letters.

[20]  Milosevic,et al.  Energy-pooling collisions in cesium: 6PJ+6PJ-->6S+(nl=7P,6D,8S,4F). , 1996, Physical review. A, Atomic, molecular, and optical physics.

[21]  Karol Waichman,et al.  Toward understanding the dissociation of I2 in chemical oxygen-iodine lasers: Combined experimental and theoretical studies , 2007 .

[22]  Raymond J. Beach,et al.  New class of cw high-power diode-pumped alkali lasers (DPALs) (Plenary Paper) , 2004, SPIE High-Power Laser Ablation.

[23]  B. Barmashenko,et al.  Static diode pumped alkali lasers: Model calculations of the effects of heating, ionization, high electronic excitation and chemical reactions , 2013 .

[24]  Antonio Sasso,et al.  Laser ionization and time-resolved ion collection in cesium vapor , 1985 .

[25]  S. Manson,et al.  Photoionization of the Cs6dexcited state , 1984 .

[26]  Boris D. Barmashenko,et al.  Feasibility of supersonic diode pumped alkali lasers: Model calculations , 2013 .

[27]  Qi Zhu,et al.  Analysis of temperature distributions in diode-pumped alkali vapor lasers , 2010 .

[28]  Timothy J. Madden,et al.  Simulation of deleterious processes in a static-cell diode pumped alkali laser , 2014, Photonics West - Lasers and Applications in Science and Engineering.