Life cycle assessment of gas atomised sponge nickel for use in alkaline hydrogen fuel cell applications

Abstract This paper presents a cradle-to-grave comparative Life Cycle Assessment (LCA) of new gas atomised (GA) sponge nickel catalysts and evaluates their performance against the both cast and crush (CC) sponge nickel and platinum standards currently used in commercial alkaline fuel cells (AFC). The LCA takes into account the energy used and emissions throughout the entire life cycle of sponge nickel catalysts – ranging from the upstream production of materials (mainly aluminium and nickel), to the manufacturing, to the operation and finally to the recycling and disposal. Through this assessment it was found that the energy and emissions during the operational phase associated with a given catalyst considerably outweigh the primary production, manufacturing and recycling. Primary production of the nickel (and to a lesser extent dopant materials) also has a significant environmental impact but this is offset by operational energy savings over the electrode's estimated lifetime and end of life recyclability. From the results it can be concluded that higher activity spongy nickel catalysts produced by gas atomisation could have a significantly lower environmental impact than either CC nickel or platinum. Doped GA sponge nickel in particular showed comparable performance to that of the standard platinum electrode used in AFCs.

[1]  T. Nissinen.  Preparation and characterisation of MnCo2O4 and Raney nickel catalysts for alkaline fuel cells , 2004 .

[2]  J. Keskinen,et al.  Processing of Raney-Nickel Catalysts for Alkaline Fuel Cell Applications , 2007 .

[3]  Hong-Ki Lee,et al.  Enhancement of catalytic activity of Raney nickel by cobalt addition , 1998 .

[4]  Iain Staffell,et al.  Life cycle assessment of an alkaline fuel cell CHP system , 2010 .

[5]  Yohannes Kiros,et al.  Long-term hydrogen oxidation catalysts in alkaline fuel cells , 2000 .

[6]  Martin Pehnt.  Assessing future energy and transport systems: the case of fuel cells , 2003 .

[7]  Enric Brillas,et al.  Fuel cells for chemicals and energy cogeneration , 2006 .

[8]  Jia Ma,et al.  A comprehensive review of direct borohydride fuel cells , 2010 .

[9]  N. Adkins,et al.  A quantitative investigation of the structure of Raney-Ni catalyst material using both computer simulation and experimental measurements , 2011 .

[10]  M. Marafi,et al.  Spent catalyst waste management: A review: Part I—Developments in hydroprocessing catalyst waste reduction and use , 2008 .

[11]  G. Kreysa,et al.  Electrochemical Engineering: Science and Technology in Chemical and Other Industries , 1999 .

[12]  Ibrahim Dincer,et al.  Sustainability aspects of hydrogen and fuel cell systems , 2011 .

[13]  N. Adkins,et al.  Influence of phase composition and particle size of atomised Ni-Al alloy samples on the catalytic performance of Raney-type nickel catalysts , 2009 .

[14]  P. Pourghahramani.  Effects of grinding variables on structural changes and energy conversion during mechanical activation using line profile analysis (LPA) , 2006 .

[15]  Nicholas J.E. Adkins,et al.  Life cycle assessment of sponge nickel produced by gas atomisation for use in industrial hydrogenation catalysis applications , 2012, The International Journal of Life Cycle Assessment.

[16]  A. Yule,et al.  Atomization of melts for powder production and spray deposition , 1994 .

[17]  Sara González-García,et al.  Environmental life cycle assessment for rapeseed-derived biodiesel , 2012, The International Journal of Life Cycle Assessment.

[18]  T. Müller,et al.  Investigations into the mechanism of the liquid-phase hydrogenation of nitriles over Raney-Co catalysts , 2008 .

[19]  C. Hendrickson,et al.  Life-Cycle Analysis of Alternative Automobile Fuel/Propulsion Technologies , 2000 .

[20]  C. Sung,et al.  A review of the performance and analysis of proton exchange membrane fuel cell membrane electrode assemblies , 2012 .

[21]  David John Jarvis,et al.  IMPRESS Integrated Project : An overview paper , 2005 .

[22]  Korneel Rabaey,et al.  Life cycle assessment of high-rate anaerobic treatment, microbial fuel cells, and microbial electrolysis cells. , 2010, Environmental science & technology.

[23]  Alexis Laurent,et al.  Limitations of carbon footprint as indicator of environmental sustainability. , 2012, Environmental science & technology.

[24]  G. Naterer,et al.  Life cycle assessment of various hydrogen production methods , 2012 .

[25]  T. Norgate,et al.  Assessing the environmental impact of metal production processes , 2007 .

[26]  S. Schmidt.  Improving Raney® Catalysts Through Surface Chemistry , 2010 .

[27]  Ali Hassan,et al.  Closed loop management of spent catalysts in the chemical industry , 2002 .

[28]  Martin Pehnt,et al.  Assessing future energy and transport systems: the case of fuel cells , 2003 .

[29]  Nigel P. Brandon,et al.  Review of gas diffusion cathodes for alkaline fuel cells , 2009 .

[30]  J. Dufour,et al.  Life cycle assessment of processes for hydrogen production. Environmental feasibility and reduction of greenhouse gases emissions , 2009 .

[31]  Nigel P. Brandon,et al.  The environmental impact of manufacturing planar and tubular solid oxide fuel cells , 2001 .

[32]  Heather L MacLean,et al.  Life cycle assessment of automobile/fuel options. , 2003, Environmental science & technology.

[33]  Patricia L. Mokhtarian,et al.  Life cycle assessment of fuel cell vehicles a methodology example of input data treatment for future technologies , 2002 .

[34]  Erich Gülzow,et al.  Alkaline fuel cells: a critical view , 1996 .

[35]  G. Reinhart,et al.  Synchrotron X-ray microtomography of Raney-type nickel catalysts prepared by gas atomisation: Effect of microstructure on catalytic performance , 2011 .

[36]  Urmila M. Diwekar,et al.  Life cycle assessment of fuel cell-based APUs , 2005 .

[37]  Tariq Muneer,et al.  Energy and environmental impact analysis of double-glazed windows , 1998 .

[38]  Michael Zwicky Hauschild,et al.  Comparison of Three Different LCIA Methods: EDIP97, CML2001 and Eco-indicator 99 , 2003 .