A reconfigurable impulse radio transmitter

To investigate impulse radio (IR) communication transceivers, bit error rate (BER) measurements are typically performed by connecting an arbitrary waveform generator and a digitizing oscilloscope. In this paper a reconfigurable software defined radio (SDR) transmitter specifically designed for IR communication tests is presented. The prototype offers the possibility to transmit arbitrary 4-ary modulated impulses with 1 GHz bandwidth over four channels in the frequency range from 6 GHz-10 GHz. For generation of intermediate frequency (IF) signals a subsampling concept with a multi-Nyquist digital to analog converter (DAC) and a field programmable gate array (FPGA) has been employed. Pseudo-coherent signals are synthesized at radio frequency (RF) by utilizing a mixer with a local oscillator (LO) frequency locked to the LO of the DAC. A comparison of theoretically derived signals and measurements shows that both are in close agreement.

[1]  Rodney G. Vaughan,et al.  The theory of bandpass sampling , 1991, IEEE Trans. Signal Process..

[2]  F. Jondral,et al.  Spectral Properties of Ultra Wideband Signals with General Time-Hopping Codes , 2005, EUROCON 2005 - The International Conference on "Computer as a Tool".

[3]  Marian Verhelst,et al.  A Low Power, Reconfigurable IR-UWB System , 2008, 2008 IEEE International Conference on Communications.

[4]  C.M. Keller,et al.  Ultra-Wideband Direct Sampling Receiver , 2007, 2007 IEEE International Conference on Ultra-Wideband.

[5]  A. T. Ott,et al.  Enhanced investigations on effective isotropic radiated power emissions of impulse radio devices , 2012, 2012 6th European Conference on Antennas and Propagation (EUCAP).

[6]  Thomas F. Eibert,et al.  Performance analysis of a software defined subsampling ultra-wideband B-/QPSK impulse radio transceiver , 2009, 2009 European Wireless Technology Conference.

[7]  Robert W. Brodersen,et al.  A Subsampling Radio Architecture for Ultrawideband Communications , 2007, IEEE Transactions on Signal Processing.

[8]  T.F. Eibert,et al.  Concept of an UWB impulse radio B-/QPSK transmitter based on standard logic components , 2008, 2008 IEEE International Conference on Ultra-Wideband.

[9]  Jeffrey H. Reed,et al.  A software-defined ultra-wideband transceiver testbed for communications, ranging, and imaging , 2006 .

[10]  Daniela Dragomirescu,et al.  Largely reconfigurable impulse radio UWB transceiver , 2010 .

[11]  Thomas F. Eibert,et al.  A reconfigurable software defined ultra-wideband impulse radio transceiver , 2010 .

[12]  J. Huttner,et al.  Pseudo-coherent software defined Ultra wideband transmitter for ranging and communication , 2012, 2012 The 7th German Microwave Conference.

[13]  Moe Z. Win,et al.  Impulse radio: how it works , 1998, IEEE Communications Letters.

[14]  Geert Van der Plas,et al.  Ultra-wide-band transmitter for low-power wireless body area networks: design and evaluation , 2005, IEEE Transactions on Circuits and Systems I: Regular Papers.

[15]  Jeffrey H. Reed,et al.  Introduction to ultra wideband communication systems, an , 2005 .

[16]  Werner Wiesbeck,et al.  EURASIP Journal on Applied Signal Processing 2005:3, 296–305 c ○ 2005 Hindawi Publishing Corporation Influence of the Antennas on the Ultra-Wideband Transmission , 2002 .

[17]  A. T. Ott,et al.  A 433 MHz-22 GHz reconfigurable dielectric loaded biconical antenna , 2010, Proceedings of the Fourth European Conference on Antennas and Propagation.

[18]  Jr. R. Wyndrum.  Microwave filters, impedance-matching networks, and coupling structures , 1965 .