Parameter Design Method of Planetary Hybrid Power-Split System

Based on the front introduction of the related theory and simulation technology in the hybrid power system, this chapter proposes a multi-factor integrated parametric design method for a power-split hybrid electric bus (HEB).

[1]  Chao Chen,et al.  Theoretic study of efficiency of two-DOFs of epicyclic gear transmission via virtual power , 2011 .

[2]  Jung Hun Kang,et al.  Design of power split transmission: Design of dual mode power split transmission , 2010 .

[3]  Guido Herrmann,et al.  Current hybrid-electric powertrain architectures: Applying empirical design data to life cycle assessment and whole-life cost analysis , 2014 .

[4]  Jorge Angeles,et al.  Virtual-Power Flow and Mechanical Gear-Mesh Power Losses of Epicyclic Gear Trains , 2007 .

[5]  Jung Hun Kang,et al.  Development of a control strategy based on the transmission efficiency with mechanical loss for a dual mode power split-type hybrid electric vehicle , 2012 .

[6]  Panos Y. Papalambros,et al.  Design Optimization of Motor/Generator Full-load Characteristics in Two-mode Hybrid Vehicles , 2009 .

[7]  Huei Peng,et al.  A systematic design approach for two planetary gear split hybrid vehicles , 2010 .

[8]  Chao Chen.  Power flow and efficiency analysis of epicyclic gear transmission with split power , 2013 .

[9]  Jinming Liu,et al.  Modeling, Configuration and Control Optimization of Power-split Hybrid Vehicles. , 2007 .

[10]  Michael Duoba,et al.  Integrating Data, Performing Quality Assurance, and Validating the Vehicle Model for the 2004 Prius Using PSAT , 2006 .

[11]  Shumei Cui,et al.  A Fuzzy Logic Global Power Management Strategy for Hybrid Electric Vehicles Based on a Permanent Magnet Electric Variable Transmission , 2012 .

[12]  Xiaowu Zhang,et al.  Design of Power-Split Hybrid Vehicles With a Single Planetary Gear , 2012 .

[13]  Wei Hua Wang,et al.  Analysis on compound-split configuration of power-split hybrid electric vehicle , 2014 .

[14]  Yimin Gao,et al.  Parametric design of power-split HEV drive train , 2009, 2009 IEEE Vehicle Power and Propulsion Conference.

[15]  Feng An,et al.  Integration of a Modal Energy and Emissions Model into a PNGV Vehicle Simulation Model, PSAT , 2001 .

[16]  Jerome Meisel,et al.  An Analytic Foundation for the Two-Mode Hybrid-Electric Powertrain with a Comparison to the Single-Mode Toyota Prius THS-II Powertrain , 2009 .

[17]  A. K. Gupta,et al.  Analysis of circulating power within hybrid electric vehicle transmissions , 2013 .

[18]  Robert Larsen,et al.  In-Situ Mapping and Analysis of the Toyota Prius HEV Engine , 2000 .

[19]  Sung-Ho Hwang,et al.  Motor control of input-split hybrid electric vehicles , 2009 .

[20]  Wen Xuhui,et al.  Optimal design of planetary gear in multi-mode hybrid drive system , 2014, 2014 IEEE Conference and Expo Transportation Electrification Asia-Pacific (ITEC Asia-Pacific).

[21]  Bo Egardt,et al.  Predictive energy management of a 4QT series-parallel hybrid electric bus , 2009 .

[22]  Narayan C. Kar,et al.  Advanced design approach of power split device of plug-in hybrid electric vehicles using Dynamic Programming , 2011, 2011 IEEE Vehicle Power and Propulsion Conference.

[23]  Jerome Meisel,et al.  An Analytic Foundation for the Toyota Prius THS-II Powertrain with a Comparison to a Strong Parallel Hybrid-Electric Powertrain , 2006 .

[24]  D. Clodic,et al.  Dynamic modeling of the electro-mechanical configuration of the Toyota Hybrid System series/parallel power train , 2011 .

[25]  Jing Sun,et al.  A Near-Optimal Power Management Strategy for Rapid Component Sizing of Multimode Power Split Hybrid Vehicles , 2015, IEEE Transactions on Control Systems Technology.

[26]  Jerome Meisel,et al.  Kinematic Study of the GM Front-Wheel Drive Two-Mode Transmission and the Toyota Hybrid System THS-II Transmission , 2011 .