Characteristics and cytocompatibility of biodegradable polymer film on magnesium by spin coating.

[1]  Yufeng Zheng,et al.  A study of TaxC1−x coatings deposited on biomedical 316L stainless steel by radio-frequency magnetron sputtering , 2010 .

[2]  Ke Yang,et al.  Fluoride treatment and in vitro corrosion behavior of an AZ31B magnesium alloy , 2010 .

[3]  R. Xin,et al.  Effect of Mg 2+ concentration on biocompatibility of pure magnesium , 2010 .

[4]  Jianwei Xu,et al.  Microstructure, mechanical properties and bio-corrosion properties of Mg-Si(-Ca, Zn) alloy for biomedical application. , 2010, Acta biomaterialia.

[5]  Yang Song,et al.  Electrodeposition of Ca-P coatings on biodegradable Mg alloy: in vitro biomineralization behavior. , 2010, Acta biomaterialia.

[6]  H. Wong,et al.  A biodegradable polymer-based coating to control the performance of magnesium alloy orthopaedic implants. , 2010, Biomaterials.

[7]  Yang Song,et al.  Research on an Mg-Zn alloy as a degradable biomaterial. , 2010, Acta biomaterialia.

[8]  J. Gray-Munro,et al.  Influence of surface modification on the in vitro corrosion rate of magnesium alloy AZ31. , 2009, Journal of biomedical materials research. Part A.

[9]  Lihua Liu,et al.  In vitro degradation behaviors of Poly-l-lactide/bioactive glass composite materials in phosphate-buffered solution , 2009 .

[10]  M. Peuster,et al.  Development and biocompatibility of a novel corrodible fluoride-coated magnesium-calcium alloy with improved degradation kinetics and adequate mechanical properties for cardiovascular applications. , 2009, Journal of biomedical materials research. Part A.

[11]  Y. Zheng,et al.  Surface modification of an Mg-1Ca alloy to slow down its biocorrosion by chitosan , 2009, Biomedical materials.

[12]  C. Xie,et al.  In vitro degradation, hemolysis and MC3T3-E1 cell adhesion of biodegradable Mg–Zn alloy , 2009 .

[13]  Akiko Yamamoto,et al.  Effect of inorganic salts, amino acids and proteins on the degradation of pure magnesium in vitro , 2009 .

[14]  Barry O'Brien,et al.  The evolution of cardiovascular stent materials and surfaces in response to clinical drivers: a review. , 2009, Acta biomaterialia.

[15]  Ke Yang,et al.  Microstructure, mechanical and corrosion properties and biocompatibility of Mg-Zn-Mn alloys for biomedical application , 2009 .

[16]  Ke Yang,et al.  Phosphating treatment and corrosion properties of Mg–Mn–Zn alloy for biomedical application , 2009, Journal of materials science. Materials in medicine.

[17]  Ke Yang,et al.  In vitro and in vivo evaluation of the surface bioactivity of a calcium phosphate coated magnesium alloy. , 2009, Biomaterials.

[18]  N. Scharnagl,et al.  Corrosion protection of magnesium alloy AZ31 by coating with poly(ether imides) (PEI) , 2009 .

[19]  R. Zeng,et al.  Characterization and wear resistance of macro-arc oxidation coating on magnesium alloy AZ91 in simulated body fluids , 2008 .

[20]  Patrick W Serruys,et al.  Fully Biodegradable Coronary Stents , 2008, American journal of cardiovascular drugs : drugs, devices, and other interventions.

[21]  H. Somekawa,et al.  Precipitation control of calcium phosphate on pure magnesium by anodization , 2008 .

[22]  Ji-Young Lee,et al.  Influence of Ca on the corrosion properties of magnesium for biomaterials , 2008 .

[23]  D. Yin,et al.  Effect of Zn on mechanical property and corrosion property of extruded Mg-Zn-Mn alloy , 2008 .

[24]  A. Gorelov,et al.  Estimation of the strength of adhesion between a thermoresponsive polymer coating and nitinol wire , 2008, Journal of materials science. Materials in medicine.

[25]  Yufeng Zheng,et al.  The development of binary Mg-Ca alloys for use as biodegradable materials within bone. , 2008, Biomaterials.

[26]  Ke Yang,et al.  In vitro corrosion behaviour of Mg alloys in a phosphate buffered solution for bone implant application , 2008, Journal of materials science. Materials in medicine.

[27]  Ke Yang,et al.  In vivo corrosion behavior of Mg-Mn-Zn alloy for bone implant application. , 2007, Journal of biomedical materials research. Part A.

[28]  Janne Laine,et al.  Cellulose nanocrystal submonolayers by spin coating. , 2007, Langmuir : the ACS journal of surfaces and colloids.

[29]  Raimund Erbel,et al.  Temporary scaffolding of coronary arteries with bioabsorbable magnesium stents: a prospective, non-randomised multicentre trial , 2007, The Lancet.

[30]  Guang-Ling Song,et al.  Control of biodegradation of biocompatable magnesium alloys , 2007 .

[31]  W. Müller,et al.  Magnesium and its Alloys as Degradable Biomaterials. Corrosion Studies Using Potentiodynamic and EIS Electrochemical Techniques , 2007 .

[32]  Karl-Heinz Waldmann,et al.  Safety and efficacy of bioabsorbable magnesium alloy stents in porcine coronary arteries , 2006, Catheterization and cardiovascular interventions : official journal of the Society for Cardiac Angiography & Interventions.

[33]  Alexis M Pietak,et al.  Magnesium and its alloys as orthopedic biomaterials: a review. , 2006, Biomaterials.

[34]  Frank Witte,et al.  In vitro and in vivo corrosion measurements of magnesium alloys. , 2006, Biomaterials.

[35]  Michael Weyand,et al.  First successful implantation of a biodegradable metal stent into the left pulmonary artery of a preterm baby , 2005, Catheterization and cardiovascular interventions : official journal of the Society for Cardiac Angiography & Interventions.

[36]  H. Haferkamp,et al.  In vivo corrosion of four magnesium alloys and the associated bone response. , 2005, Biomaterials.

[37]  Raimund Erbel,et al.  Drug-eluting bioabsorbable magnesium stent. , 2004, Journal of interventional cardiology.

[38]  S. Sen,et al.  Studies on the influence of chloride ion concentration and pH on the corrosion and electrochemical behaviour of AZ63 magnesium alloy , 2004 .

[39]  R. Reis,et al.  Bioinert, biodegradable and injectable polymeric matrix composites for hard tissue replacement: state of the art and recent developments , 2004 .

[40]  J. G. Kim,et al.  Localized corrosion mechanisms of the multilayered coatings related to growth defects , 2004 .

[41]  A Haverich,et al.  Left main coronary artery fistula exiting into the right atrium , 2003, Heart.

[42]  C. B. Carter,et al.  Indentation deformation and fracture of thin polystyrene films , 2002 .

[43]  M. Maguire,et al.  Magnesium chemistry and biochemistry , 2002, Biometals.

[44]  B. Luan,et al.  Protective coatings on magnesium and its alloys — a critical review , 2002 .

[45]  Jia-Hong Huang,et al.  Corrosion behavior and adhesion of ion-plated TiN films on AISI 304 steel , 2000 .

[46]  K. R. Baldwin,et al.  Corrosion behaviour of some vapour deposited magnesium alloys , 1996 .

[47]  J. Kruger,et al.  Corrosion of magnesium , 1993 .

[48]  P. Nagy,et al.  Hydrolysis Induced Deterioration of Compressive Properties of Poly-ε- Caprolactone , 2009 .

[49]  M. Staiger,et al.  Bone-like matrix formation on magnesium and magnesium alloys , 2008, Journal of materials science. Materials in medicine.

[50]  Yang Ke.  Preparation and property of coating on degradable Mg implant , 2007 .

[51]  Anil Kumar,et al.  CELL SURFACE INTERACTIONS IN THE STUDY OF BIOCOMPATIBILITY , 2002 .