Development of a Dynamic Oriented Rehabilitative Integrated System (DORIS) and Preliminary Tests

Moving platforms were introduced in the field of the study of posturography since the 1970s. Commercial platforms have some limits: a limited number of degrees of freedom, pre-configured protocols, and, usually, they are expensive. In order to overcome these limits, we developed a robotic platform: Dynamic Oriented Rehabilitative Integrated System (DORIS). We aimed at realizing a versatile solution that can be applied both for research purposes but also for personalizing the training of equilibrium and gait. We reached these goals by means of a Stewart platform that was realized with linear actuators and a supporting plate. Each actuator is provided by an ad hoc built monoaxial load cell. Position control allows a large range of movements and load cells measure the reactive force applied by the subject. Transmission Control Protocol/Internet Protocol (TCP/IP) guarantees the communication between the platform and other systems. We integrated DORIS with a motion analysis system, an electromyography (EMG) system, and a virtual reality environment (VR). This integration and the custom design of the platform offer the opportunity to manipulate the available information of the subject under analysis, which uses visual, vestibular, and plantar feet pressure inputs. The full access to the human movements and to the dynamic interaction is a further benefit for the identification of innovative solutions for research and physical rehabilitation purposes in a field that is widely investigated but still open.

[1]  Antonio Morell,et al.  Solving the forward kinematics problem in parallel robots using Support Vector Regression , 2013, Eng. Appl. Artif. Intell..

[2]  F. Honegger,et al.  Vestibular influences on human postural control in combinations of pitch and roll planes reveal differences in spatiotemporal processing , 2001, Experimental Brain Research.

[3]  Jon Trevelyan,et al.  Development of an instrumented pole test for use as a gait laboratory quality check. , 2007, Gait & posture.

[4]  J.H.J. Allum,et al.  Directional aspects of balance corrections in man , 2003, IEEE Engineering in Medicine and Biology Magazine.

[5]  Ashitava Ghosal,et al.  A force–torque sensor based on a Stewart Platform in a near-singular configuration , 2004 .

[6]  Steven J Stanhope,et al.  In situ calibration and motion capture transformation optimization improve instrumented treadmill measurements. , 2009, Journal of applied biomechanics.

[7]  R. Woodworth,et al.  The Integrative Action of the Nervous System , 1908 .

[8]  W. Smith.  The Integrative Action of the Nervous System , 1907, Nature.

[9]  Q. Liao,et al.  Forward Kinematics of the 6-6 Stewart Platform with Planar Base and Platform Using Algebraic Elimination , 2007, 2007 IEEE International Conference on Automation and Logistics.

[10]  John P Holden,et al.  A proposed test to support the clinical movement analysis laboratory accreditation process. , 2003, Gait & posture.

[11]  Adrian Lees,et al.  Kinematic response characteristics of the CAREN moving platform system for use in posture and balance research. , 2007, Medical engineering & physics.

[12]  L. Nashner.  Adapting reflexes controlling the human posture , 1976, Experimental Brain Research.

[13]  Yunfeng Wang.  An Incremental Method for Forward Kinematics of Parallel Manipulators , 2006, 2006 IEEE Conference on Robotics, Automation and Mechatronics.

[14]  Steven H Collins,et al.  A simple method for calibrating force plates and force treadmills using an instrumented pole. , 2009, Gait & posture.

[15]  Yohan Dupuis,et al.  A Study of Vicon System Positioning Performance , 2017, Sensors.

[16]  Charles C. Nguyen,et al.  Efficient computation of forward kinematics and Jacobian matrix of a Stewart platform-based manipulator , 1991, IEEE Proceedings of the SOUTHEASTCON '91.

[17]  Morgan Quigley,et al.  ROS: an open-source Robot Operating System , 2009, ICRA 2009.

[18]  M. Ferrarin,et al.  Spot check of the calibrated force platform location , 2006, Medical and Biological Engineering and Computing.

[19]  Bhaskar Dasgupta,et al.  Design and development of a Stewart platform based force– torque sensor , 2001 .

[20]  R. Shiavi,et al.  Simultaneous measurement of body center of pressure and center of gravity during upright stance. Part I: Methods , 1996 .

[21]  L. W. Faulkner,et al.  Design, control, and characterization of a sliding linear investigative platform for analyzing lower limb stability (SLIP-FALLS) , 1998 .

[22]  Charles J Robinson,et al.  Effect of lateral perturbations on psychophysical acceleration detection thresholds , 2005, Journal of NeuroEngineering and Rehabilitation.

[23]  G. Oriolo,et al.  Robotics: Modelling, Planning and Control , 2008 .

[24]  K. Srinivasan,et al.  Kinematic and dynamic analysis of Stewart platform-based machine tool structures , 2003, Robotica.

[25]  Thomas Sinkjær,et al.  Robotic Platform for Human Gait Analysis , 2007, IEEE Transactions on Biomedical Engineering.

[26]  Tiago Charters,et al.  Detecting Singularities of Stewart Platforms , 2009 .

[27]  Hong Gu,et al.  Forward kinematics analysis of a six-DOF Stewart platform using PCA and NM algorithm , 2009, Ind. Robot.

[28]  Vladimir M. Zatsiorsky,et al.  Biomechanics and Motor Control: Defining Central Concepts , 2015 .

[29]  A. de Kleijn,et al.  Die Abhängigkeit der Körperstellung vom Kopfstande beim normalen Kaninchen , 1913, Pflüger's Archiv für die gesamte Physiologie des Menschen und der Tiere.

[30]  J Browne,et al.  A quality control procedure for force platforms. , 2000, Physiological measurement.

[31]  J. Allum,et al.  Postural responses to multidirectional stance perturbations in cerebellar ataxia , 2006, Experimental Neurology.

[32]  S Corna,et al.  Postural coordination in elderly subjects standing on a periodically moving platform. , 2000, Archives of physical medicine and rehabilitation.

[33]  D. Stewart,et al.  A Platform with Six Degrees of Freedom , 1965 .